Franklin Electric SubDrive15 Connect N3R Manuals

SubDrive/MonoDrive Connect SubDrive15, SubDrive20, SubDrive30, MonoDrive, MonoDriveXT Fan Replacement Install Guide If the fan does not perform as stated above, note the error and consult your local Franklin Electric representative or call the Franklin Electric Technical Service Hotline at 1-800-348-2420. Fan Test 1. The fan can be unplugged from the drive and tested with a 9 V battery to show functionality. - Connect the red (+) lead from the battery to the red fan connector, and the black (-) lead from the battery to the black fan connector. - Connect the battery clip to the 9 V battery. The fan should spin freely and quietly. 2. Test that the fan power supply works properly. - Cycle power to the drive. - Verify that the fan runs for 3–5 seconds during the power-up initialization. SUBDRIVE/MONODRIVE CONNECT FAN REPLACEMENT INSTALL GUIDE s WARNING ! Serious or fatal electrical shock may result from contact with the internal electrical components. DO NOT, under any circumstances, ATTEMPT TO CHANGE THE FAN until the power has been removed from the drive, capacitors are discharged, and five minutes have passed for internal voltages to discharge! Before replacing the fan, make sure the fan is not working properly by performing the simple test below: STEP 1: Verify the fan replacement kit. STEP 2: Remove the rivets from the bottom of the enclosure. SubDrive/MonoDrive Size Fan Kit No. Fan Cover SubDrive15 and MonoDrive 80 mm (3.15”) 226545904 Integrated SubDrive20/30 and MonoDriveXT 80 mm (3.15”) 226545905 Integrated Integrated Enclosure Fan Cover SUBDRIVE/MONODRIVE CONNECT FAN REPLACEMENT INSTALL GUIDE s WARNING ! REMOVE ALL INCOMING ELECTRICAL POWER TO THE DRIVE. THIS IS A NON-POWERED ELECTRIC PROCEDURE.