Franklin Fueling Systems INCON Colibri Series Manuals

1 of 2 Colibri System Board Field Replacement Instructions Tools Needed • ¼ Inch nut driver • #2 Phillips screwdriver. Backup Settings If replacing a board that can still communicate, connect to it and download setup, registration file and database. To backup the data, use the TSA Upgrade tool. Refer to INCON document 000-0075 for information about downloading and using the upgrade tool. Individually select the tabs Registration, Setup and Database and in each case click Save. Figure 1: Upgrade Tool Screen Removing Existing System Board 1. Remove electrical power from unit at the breaker. 2. Remove the front cover from the unit. 3. Disconnect the plugs from the Power, Relay and Probe receptacles and any communication cables or USB sticks attached to communication ports. 4. Loosen the two screws on the left hand side of the power brick (1 and 2 in Figure 2). Do not pull the screws out. 5. Remove the two screws on the right hand side of the board (4 and 5 in Figure 2) and set them aside with the Intrinsically Safe shield and the display ground strap. 6. Remove the standoffs from the top right and bottom left corners of the board (3 and 4 in Figure 2). 7. Grasp the board and gently pull out from the top. Once the top portion is an inch or so from the enclosure gently lift the board up and out of the enclosure. Before placing the replacement board in the enclosure, first remove the two lock nuts from the left hand side of the power block/brick (1 and 2 in Figure 2) being careful that the screws do not drop out. Use the two nuts to secure the two screws on the unit that was removed. There will also be a locknut under the standoff in location 4. The replacement board that is being installed will be one of two types: • CL-MBXX Spare controller module, Fuel Management System Application only, no software options • CL-MBXX Replacement controller module, factory programmed with the systems required options If the system is having the board replaced with a spare module, the board may need to be upgraded to regain either SCALD or TRAC software options. This is only if the original system had these software options included. The TSA Upgrade tool can be used to upgrade the CL- MBXX. For assistance with upgrades, contact the FFS Technical Support Team. If the CL-MBXX is ordered for the correct serial number of the system, the board will have the necessary software options installed. This will be a “plug and play” board replacement. Part # Description CL-MB CL6 Replacement mainboard, no display CL-MB/R CL6 Replacement mainboard, no display with required options CL-MBWD CL6 Replacement mainboard with display CL-MBWD/R CL6 Replacement mainboard with display and required options