Frigidaire FRT15B3J Manuals

This document should only be removed by customer after installation. P/N: 240568304 Not satisfied with the installation of your refrigerator?  Please contact the store you purchased it from. Installation Instructions for Top Mount Refrigerator 2 3 To connect the water supply to the rear of your refrigerator: 1 Ensure that the refrigerator is not plugged in. 2 Flush the supply line until water is clear by placing the end of the copper tube in a sink or bucket and opening the shut-off valve. 3 Remove the plastic cap from the water valve inlet at the rear of your refrigerator. Discard the cap. 4 Slide the brass compression nut, then the ferrule (sleeve) onto copper tube. 5 Push the copper tube into water valve inlet as far as it will go (1/4 inch). 6 Slide the ferrule (sleeve) into valve and finger-tighten the compression nut onto valve. Tighten another half turn with a wrench. Do not over-tighten. 7 Secure the copper tube to your refrigerator’s rear panel with a steel clamp and screw (see illustration). 8 Coil the excess copper tubing (about 2½ turns) behind your refrigerator as shown. Arrange coiled tubing to avoid vibration or wear against other surfaces. 9 Open water supply shut-off valve and tighten any connections that leak. 5 Remove Internal Shipping Materials 7 8 1 4 6 9 Doors  Handles are secure and tight  Door seals completely to cabinet on all sides  Freezer door is level across the top Leveling  Refrigerator is level, side to side and tilted 1/4” (6mm) front to back  Toe grille is properly attached to refrigerator  Cabinet is setting solid on all corners Electrical Power  House power turned on  Refrigerator plugged in Ice Maker  House water supply connected to refrigerator  No water leaks present at all connections - recheck in 24 hours  Ice Maker is turned ON. Final Checks  Shipping material removed  Fresh Food and Freezer controls set  Crisper Humidity controls set  Registration Card sent in Installation Checkoff List Prepare The Installation Site Transport Unpackaged Refrigerator To Site Location of these materials may vary depending on your model. Plastic Putty Knife Adjustable Wrench Socket Wrench Set OR Phillips head or Quadrex head screwdriver ™ ™ Tools Necessary: Pliers Awl (OR) Include these minimum guidelines in your site preparation: • Choose a place near a grounded electrical outlet. • Do not use an extension cord or an adapter plug. • Avoid direct sunlight and close proximity to a range, dishwasher or other heat source. • Floor should be level and able to support a fully loaded refrigerator. Allow the following clearances for ease of installation, proper air circulation, and plumbing and electrical connections: Sides & Top: 3/8 inch Rear: 1 inch By now, you have already removed your refrigerator’s shipping carton. You may still need to use a hand truck to move it through close spaces or entrances. If the refrigerator is larger than an entrance, consider two options: • Remove the entrance door if one exists. • Remove the refrigerator doors (see how in your Use & Care Guide). When using a hand truck: • Load refrigerator from side of cabinet only. • Do not run retaining straps over handles. • Do not over-tighten retaining straps. • Never use refrigerator handles to move the refrigerator. • Remove tape from doors only after unit is in place. Connect Water Supply What you will need: • Access to a cold water line with pressure of 30-100 psi. • Copper tubing with ¼-inch (6.4mm) OD. Length for this tubing is the distance from the rear of the refrigerator to your household water supply line plus 7 feet (2.1 meters). • A shut-off valve for the connection between your household water line and the refrigerator supply line. Do not use a self-piercing shut-off valve. • A compression nut and ferrule (sleeve) for the water supply connection at the rear of your refrigerator. Place In Permanent Position If possible, use a hand truck to position the refrigerator directly in front of its cabinet enclosure. Be careful not to move the refrigerator beyond its water supply (copper tubing) connections. Plug in the power cord, and push the refrigerator straight back into place. Level Refrigerator & Adjust Doors (if necessary) Guidelines for final positioning of your refrigerator: • All four corners of the cabinet must rest firmly on the floor. • The cabinet should be level at the front and rear. • The sides should tilt ¼-inch (6 mm) from front-to-back (to ensure that doors close and seal properly). • Doors should align with each other and be level. To level the cabinet using the front rollers: 1 Remove the toe grille. 2 Use a flat-blade screwdriver or 3/8 inch socket wrench to raise or lower the front rollers. Use adjustable wrench to adjust leveling screws. We use packing foam and tape to secure the internal parts of your refrigerator for shipping. Once the refrigerator is in position, you can remove this material. Controls When changing controls, wait 24 hours before making additional adjustments. Door Removal (if necessary) If you need to remove the doors to get your refrigerator into the house, please see “Door Removal Instructions” in your Use & Care Manual. WARNING To avoid electric shock, which can cause death or severe personal injury, do not connect your refrigerator to an electrical power source until you have completed Step 3 of these instructions. CAUTION Room temperatures below 55°F (13°C) or above 110°F (43°C) will impair cooling ability of your refrigerator’s compressor. IMPORTANT If you are installing your refrigerator without connecting it to a water supply, make sure the ice maker’s power switch is turned Off (see the Use & Care Guide for more details). NOTE These installation instructions are provided only as a possible customer option. We recommend that you use a service or kitchen contracting professional to install your refrigerator. NOTE Information about cabinetry construction for your new appliance is available for contractors. Call 1-877-435-3287. CAUTION Shifting the refrigerator from side to side may damage flooring. NOTE Kit #53039117950, available from your dealer, provides all materials for a water supply installation, including 25 feet of copper tubing and full instructions. CAUTION To avoid property damage: • Use copper tubing for the water supply line (plastic tubing is more likely to leak). • Ensure water supply complies with local plumbing codes. CAUTION • Shifting the refrigerator from side to side may damage flooring. • Do not block the toe grille on the lower front of your refrigerator. Sufficient air circulation is essential for proper operation. NOTE • The ice maker’s fill valve may operate noisily if the household water supply is shut off. • After ensuring no water leaks exist at any connection, be sure to check for leaks again in 24 hours. Toe Grille Raise Stationary Front Roller with Leveling Screw (some models) Adjustable Front Roller (some models) NOTE Raise the front of the refrigerator enough so the doors close freely when opened halfway. The refrigerator should slope 1/4 inch to 1/2 inch from front-to-back. Then level the refrigerator from side-to- side. Humidity Control Top Hinge Cover Top Hinge Center Hinge Shim Pin Door Stop Door Stop Screw Hinge Pin Screws Bottom Hinge Toe Grille Washer

N05L00004.eps N05DBDCJA1.eps N05BBAABA21.eps N05SADDCA21.eps N05CBABAB5.eps W241582401.eps S241582801.eps Product No. FRT15B3JQ2 FRT15B3JW2 FRT15B3JZ2 Series R134a R134a R134a Color bisque (right) white (right) white (left) Volts 115 115 115 Wiring Diagram 241582401 241582401 241582401 Owner's Guide 241857201 241857201 241857201 Market North America North America North America Energy Guide 241613767 241613767 241613767 Service Data Sheet 241588203 241588203 241588203 Installation Instructions 241568303 240568303 240568303 P.O. BOX 212378 AUGUSTA, GA 30917 Publication No. 5995525424 08/10/02 (EN/SERVICE/DCS) 390 TOP-MOUNT REFRIGERATOR Model No. FRT15B3J Copyright ©All rights reserved.

N05L00004.eps N05DBDCJA1.eps N05BBAABA26.eps N05SADDCA21.eps N05CBBBAC7.eps W241582401.eps S241582801.eps Product No. FRT15B3JQ0 FRT15B3JW0 FRT15B3JZ0 Series R134a R134a R134a Color bisque (right) white (right) white (left) Volts 115 115 115 Wiring Diagram 241582401 241582401 241582401 Owner's Guide 241857201 241857201 241857201 Market North America North America North America Energy Guide 241613767 241613767 241613767 Service Data Sheet 241588203 241588203 241588203 Installation Instructions 240568303 240568303 240568303 P.O. BOX 212378 AUGUSTA, GA 30917 Publication No. 5995505848 08/01/29 (EN/SERVICE/DCS) 390 TOP-MOUNT REFRIGERATOR Model No. FRT15B3J Copyright ©All rights reserved.

P/N 241857201 (Sept 2007) Important Safety Instructions ........... 2 Installation .......................................... 3 Connecting Water Supply ................. 4 Door Removal Instructions ............... 5 Temperature Controls ....................... 8 Ice Service .......................................... 9 Normal Operating Sounds & Sights. 10 Care and Cleaning ............................. 10 Warranty ............................................. 12 Before you Call .................................. 13 Use & Care Manual Refrigerator Top Mount Got Questions? Need Parts or Service? Before Calling Your Local Repair Service - CALL: (United States) 1-800-944-9044 (Canada) 1-800-668-4606 √√√√√ Resolve many service issues over the phone at your convenience! √√√√√ If we can’t resolve your service issue, we’ll schedule a reputable local service technician for you! √√√√√ Order Genuine Electrolux Parts & Accessories √√√√√ Purchase Extended Warranty Protection Solutions Hotline READ AND SAVE THESE INSTRUCTIONS