FSA GT1-13 Manuals

GT1-13 / 14 / 17 Instruction Manual Installation: Wash your hands thoroughly before handling the various parts 1. Take the ceramic filter, multi layer cartridge and mineral stone box, rinse them under running water, please ensure to rinse them thoroughly. You must also use a scourer to scrub the ceramic dome to clear any ceramic fines. 2. Wash the lower tank and attach the tap, using the washers provided. Do not over/under tighten these 3. Place the mineral stone box in the lower tank. If you purchased mineral balls you can pour them around the base after installing the mineral pad 4. Take the multi layer cartridge and screw into its seating/holder carefully on the joining ring, do not overtighten 5. Place the assembled joining ring on top of the lower tank. 6. Take the upper tank and insert the ceramic filter, the washer must be on the inside again, do not overtighten. 7. Place the top tank together with the appropriate fittings for the model onto the joining ring. 8. Check all parts for fittness and alignment. 9. Fill the upper tank with water and put the top cover in place. Please Note: 1. Never use hot water. 2. Always discard the first container of water after initial purification. 3. Never use anything abrasive on the plastic parts, a sponge for washing is best 4. The ceramic filter can be cleaned using a scourer. Care must be taken, gentle circular movements over the surface of the filter will quickly clean and restore it's efficiency. 5. The ceramic filter can be cleaned up for estimated 300 times before replacing. 6. The multi cartridge needs no attention or washing, and will serve for at least 5000 litres throughput depending on the quality of the water input. We recommend replacement of this element every 6-8 months.