Furuno MCU-005 Manuals

1 MCU-002 / MCU-004 / MCU-005 Remote Control Units This document describes specifications, functions, and installation of these control units.

www.furuno.com INSTALLATION INSTRUCTIONS MCU-005 CONTROL UNIT The following installation instructions cover how to install the MCU-005 Control Unit. Before installation, check the notes below regarding running of the cables. The MCU-005 is designed to be flush-mounted in a console or panel. Note regarding running of the cables To reduce stress on the connectors, prevent accidental disconnection and also to prevent water intrusion, make sure that the wiring at the rear of the control unit meets the following recommen- dations. • Cables should not be run upwards from the units. Make sure the cable are run downwards. • Cables should be bundled together with sufficient slack to allow service and maintenance. • Bundled cables should be secured in a manner that prevents stress on the connectors, caused by heave and pitch. The figures below show examples of cabling, along with the above recommendations. Packing list MCU-005 MODIFICATION KIT (Type: OP19-19, Code: 001-506-900) Note: “*” indicates revision/version number. Part name Type Code Amount CONTROL UNIT MCU-005 1 PANEL REMOVER 19-028-3124 100-340-471-10 1 LAN CABLE ASSEMBLY MOD-Z072-050+ 001-167-890-10 1 PACKING BB 19-028-1581 100-340-742-10 1 SELF TAPPING SCREW 4x20 SUS304 000-158-850-10 4 FLUSH MOUTNING TEMPLATE C42-00703-* 000-167-223-1* 1 Cables should not be routed in a way that allows moisture or water to drip into the unit. Cables should not be hung freely. This causes stress on the connectors and may cause disconnections. Cables should be bundled with a wire-tie and secured against the inside of the console or to a bulkhead. There should be enough slack in the cables to allow service and maintenance. MCU-005 MCU-005 Other equipment MCU-005 Other equipment