GE GTQ130PANR Manuals

1 • Unstable installation may cause vibration and noise. • Wooden floor or carpet beneath the refrigerator may be decolourized. • Doors may not close properly if the refrigerator is not leveled. • Leave more than 6cm from 3 sides for ventilation. • Insufficient spacing may lead to noise,vibration, lowering of refrigerating perforormance and energy efficiency. • Direct sun light, heat of stove or gas range may decrease the refrigerating performance. • Avoid moisture and water for prevention of rusting corrosion and electrical problems. • Locate the refrigerator on concrete / cement floor or solid board or plank. 1. Installation Instructions Where the floor is solid and leveled Where ventilation is good Where there is little or no heat, moisture Suitable Installation Place Grounding is necessary all the time Grounding by using grounding wire Grounding by using short-circuit breaker Grounding is not necessary You should not connect the ground wire to * The refrigerator is grounded if a 3-prong plug is used (depending on local electric code.) I Grounding terminal is the yellow/green one connected to the power cord in the back of refrigerator. Bury copper plate to 25 cm deep in the ground with ground wire connected. Short-circuit breaker is a must where the floor is always wet, for example, fish shop, restaurant kitchen etc. in case of using side-grounded outlet. water pipe, gas pipe, telephone line, lightening-rod. There can be explosion or fire. Grounding wire Side Grounded outlet Grounding Correct usage of Refrigerator Plug in the refrigerator right after installation. Set the fresh food compartment’ temperature to “7” to perform preparatory run for 2 or 3 hours. When the inside is cold enough, put the foods in. * See page for details. * When the surrounding temperature is hot in midsummer, do not open and shut the doors too often after installation. 2