GE ZIC360NM Manuals

Monogram. ™ ZIC360NM – GE Monogram 36" Built-In Bottom Freezer Refrigerator with Automatic Icemaker Water and Electrical Locations Electrical and water supply must be located as shown. The cutout depth must be 24" Designed for industry standard flush installation. The refrigerator will project forward, slightly beyond adjacent cabinetry, depending on your installation. Cutout depth beneath a soffit When installed beneath a soffit, the soffit cannot exceed the 24" installation depth shown. The top case trim overlaps the bottom of the soffit. Frameless Cabinets The case trim overlaps cabinets at the top and sides. Therefore, frameless cabinets may require filler strips to prevent interference with cabinet door swing. The opening must allow for filler strips. Additional Specifications • A 115 volt 60Hz., 15 or 20 amp power supply is required. An individual properly grounded branch circuit or circuit breaker is recommended. Install a properly grounded 3-prong electrical receptacle recessed into the back wall. Electrical must be located on rear wall as shown. Note: GFI (grounded fault interrupter) is not recommended. • Water line can enter the opening through the floor or back wall. The water line should be 1/4" O.D. copper tubing between the cold water line and water connection location, long enough to extend to the front of the refrigerator. Installation of an easily accessible shut off valve in the water line is recommended. Optional Panel Kits: • ZPBC360: Black Panel Kit • ZPWC360: White Panel Kit • ZPSC360: Stainless Steel Panel Kit Optional Custom Trim Kits: • ZKHCSS2: Tubular Stainless Steel handles • ZUG2: Unified Grille Kit Product Clearances These refrigerators are equipped with a 2 position door stop. The factory set 130° door swing can be adjusted to 90° if clearance to adjacent cabinets or walls is restricted. Allow 25" minimum clearance for a full 130° door swing. Allow 15" for pan removal. 4" minimum clearance is required when door swing is adjusted to 90°. If the 90° door stop position is used, pan access is maintained, but pan removal is restricted. 36" Frame to Frame Width *84" From Floor to Top Frame 35" Case Width *83-1/2" at Rear 23-7/8" Behind Frame 36-3/4" 4" Minimum to Wall 90° Door Swing 90° 25" Minimum to Wall 130° Door Swing 130° The Installation Space 7" Wall View Electrical Area 84-1/2" max 83-1/2" min Finished Opening 74-1/2" From Floor to Bottom of Electrical 10" 5" 3 1/2" 5" 3 1/2" Water Supply 24" Cutout Depth 35-1/2" Finished Width 2-5/16" The finished cabinet width must be 35-1/2". Dimensions and Clearances * Shipping height. The refrigerator can be adjusted to fit into a cutout that is 83-1/2" min. to 84-1/2" max. height. Note that the top case trim at the front is 1/2" higher and will overlap upper cabinetry or soffit. Use leveling legs and wheels for height adjustment. Specification Revised 8/02 For answers to your Monogram,® GE Profile™or GE appliance questions, visit our website at GEAppliances.com or call GE Answer Center® service, 800.626.2000. R Listed by Underwriters Laboratories