Gecko in.xe-5 0602-221063-299 Manuals

2- Connect the main power Don't forget that the voltage is determined by the cable used (120 or 240 V cable)! 1- Connect all outputs & keypads OUT1 OUT2 OUT3 OUT4 3- Select spa configuration (see chart next page) 3 At first startup the keypad display will showõL 1 OR LL 1. Use the Up/Down key to choose the new low level configuration number. Press the Program key to confirm the selection. 2 1 L1 - Light connector CO - Communication link C - Main keypad connector OUT5 Ground Ground L2 N L1 L1 Ground L2 L1 For 120 V (*3 wires) * If connected to a 3 wire system all 240 V components will not work. The heat.wav heater is factory configured 240 V/4 kW (or 2 kW), but it can be converted to a dedicated 120 V / 1 kW by a simply switching the cable connection port. Option available on North American models only. Heat.wav specification summary: t
4VQQPSUT

7
PS

7 t
1SPUFDUFE
CZ
FYUFSOBM
CSFBLFS
OPU
GVTFE t
*ODPMPZ® or Titanium (optional) heater element for greater protection against corrosion. Connection for 240 V / heater (4 kW) Connection for 120 V / heater (1 kW) Ground N L1 For 240 V (4 wires) WARNING! All connections must be made by a qualified electrician in accor- dance with the national electrical code and any state, provincial or local electrical code in effect at the time of the installation. This product must always be connec- ted to circuit protected by a Ground Fault Circuit Interrupter (GFCI). 2.a- Electrical wiring 2.b- Heater voltage Note: 4o re-enter the Low level selection menu, hold the Pump 1õ key for 30 seconds. Note If the keypad does not have a ProgramõorõFilter key, use the Lightõ key instead. Note: For the Color keypad series õ select Settings menu, go into Electrical config and choose the appropriate Low level. For more information, see our website: www.geckoalliance.com GFCI b 60 A 48 A 50 A 40 A 40 A 32 A 30 A 24 A 20 A 16 A 15 A 12 A Press and hold the Program key for 20 seconds until you access the breaker setting menu. Note: For the Color keypad series õ select Settings menu, go into Electrical config and choose Input current. Use the Up/Down key to select the desired value. Then press the Program key to confirm the selection. Note: If the keypad does not have the Program or Filter key, use the Light key instead. The values displayed by the system DPSSFTQPOE
UP

PG
UIF
NBYJNVN
amperage capacity of the GFCI. 4- Select breaker current  (10 to 20 A dedicated to 120 V) 3 2 1 For more information, see our website: www.geckoalliance.com Quick Start Card in.xe-5™ North American version