Genius KYE Systems Micro Traveler 9000R Manuals

English 1 Getting Started: 1. Before you can use this device, it needs to be charged, so connect the micro USB cable to Micro Traveler 9000R and any USB port on your PC. It takes approximately two until three hours to fully charge. 2. In charging mode, the LED light will be on and will turn off when charged. 3. Connect the USB receiver to any USB port on your PC. 4. Make sure that you have switched on the power switch underneath the mouse. Note: If the LED is flashing, you need to recharge the mouse immediately. Mouse Button Assignments 1. Left Button: Provides traditional mouse functions like click, double click and drag. 2. Magic-Roller: Press the “Magic-Roller” to surf the Internet and Windows documents. 3. Right Button: Provides traditional mouse click functions. 4. LED indicator: Indicates device Starting/Charging/Battery low - Starting: LED lights up for three seconds to initiate. - Charging: LED light is ON. - Fully charged: LED light is OFF. - Battery low: LED will flash at a slow speed to indicate low battery power. Note: Download the programmable driver from our website: www.geniusnet.com Warning: (Troubleshooting) 1. Do not use the wireless optical/laser mouse on a desk which is made of glass or mirror. 2. The connection of the wireless device is factory preset, so when you plug the USB receiver into any USB port, the connection between the micro receiver and the mouse will be established automatically. 3. In case your PC did not install the hardware successfully, remove the micro receiver from the USB port and go Human Interface Devices under Device Manager to remove the mouse then plug in the micro receiver to a USB port again. 4. If you feel the mouse does not move smooth as usual, you need to recharge the mouse immediately.