Glacier bay DSDECWHT12 Manuals

TOOLS REQUIRED Claw hammer Safety goggles Phillips screwdriver Power drill Measuring tape Wall hardware Caulk/sealant Masking Tape Level HARDWARE INCLUDED AA - Knobs x 4 BB - Short Screws x 2 CC - Long Screws x 2 DD - 1/4 in. Spacers x 2 Use and Care Guide Floor Hutch Item #1001 768 028 Model #DSDECWHT12 Wall-Vanity-Hutch-Vanity Configuration: A 5/8 in. spacer is needed to allow the Floor Hutch to be secured flush with the first Vanity Unit. The 5/8 in. spacer is available through customer service (free of charge). The two 1/4 in. spacers (DD) provided are used to install the second Vanity Unit flush with the Floor Hutch. The top overhang will be shifted to the outer side of the Vanity Unit. The Floor Hutch top will be centered. Hutch-Vanity-Hutch- Configuration: When the Vanity Unit is installed with two Floor Hutches, four 5/8 in. spacers are needed. The 5/8 in. spacers are available through customer service (free of charge). After installation, use silicone to seal the space between the Vanity Unit top and Floor Hutch side panel (A). The Floor Hutch tops will be centered. OVERHANG 1/4 IN. SPACER (DD) 5/8 IN. SPACER 1/2 IN. OVERHANG WALL 5/8 IN. SPACERS Configuration Options Stand-Alone Configuration: If a Vanity Unit and Floor Hutch are installed separately, there is no need to use the 1/4 in. spacers (DD) provided with the Floor Hutch. The tops will be centered on unit(s) with equal overhang. Wall-Hutch-Vanity Configuration: The two 1/4 in. spacers (DD) are used to allow the Floor Hutch to be secured flush with the Vanity Unit. Both tops will be installed flush on one side and the 1/2 in. top overhang will be shifted to the opposite side. Vanity-Hutch Configuration: If a Vanity Unit and Floor Hutch are tied together but not butted against a wall, the two 1/4 in. spacers (DD) are used to tie the Floor Hutch and Vanity Unit together. The 1/2 in. top overhang is shifted to one side of the Vanity Unit. The Floor Hutch top is centered on the unit with equal overhang. EQUAL OVERHANG OR OVERHANG 1/4 IN. SPACER (DD) 1/4 IN. SPACER (DD) TOP OVERHANG WALL 1/4 IN. SPACER (DD) Wall-Vanity-Hutch Configuration: A 5/8 in. spacer is needed to allow the Floor Hutch to be installed flush with the Vanity Unit and provide space for the top overhang between the Vanity Unit and Floor Hutch. The 5/8 in. spacer is available through customer service (free of charge). WALL OVERHANG 5/8 IN. SPACER IS USED TO FILL GAP BEHIND THE FACE FRAME AND TIE THE UNITS TOGETHER. A HOMEDEPOT.COM/GLACIERBAY Please contact 1-888-774-8062 for further assistance.