Glasdon Signmaster Ultra Manuals

concrete 100 (min. distance from any edge of the concrete) Position the Bollard (Item 1) centrally on the intended site and orientate it correctly with regard to the site requirements (i.e. Retroreflective Sign Faces and Fluorescent Yellow Panels). Using the Bollard, mark out the 4 x hole positions, ensuring they are a minimum of 100mm from the edge of the concrete foundation. Drill the 4 x Ø16mm holes no less than 80mm deep ensuring they match the hole centres of the Bollard base. Insert an Anchor Rawl Plug (Item 2) into each of the 4 x drilled holes, then using a hammer (if required), tap flush with the ground level. Bollard Installation: Place Washer (Item 3) on top of the Anchor and align the centres. Spray a suitable Lubricant/Grease (e.g. WD40) generously into the threads of the 4 x Anchors (to aid assembly and future removal). Orientate the Bollard correctly aligning all 4 x holes to the Anchors. Insert Spacer (Item 4) into each of the 4 x fixing holes in the Bollard base. Orientate correctly and place Cover-Cap Washer Plate (Item 6), followed by Washer (Item 5) onto each of the 4 x Screws (Item 7), then secure the Bollard to the Anchors using a 6mm Allen Key. To complete, snap-fit a Cover-Cap (Item 8) over each of the 4 x Screws. Signmaster Ultra™ INSTALLATION AND MAINTENANCE INSTRUCTIONS KIT CONTENTS: ITEM 1 - Bollard x 1 ITEM 2 - Anchor Rawl Plug x 4 ITEM 3 - Washer - M10 x 30mm x 4 ITEM 4 - Spacer - M10 x 28mm x 4 ITEM 5 - Washer - M10 x 50mm x 4 ITEM 6 - Cover Cap Washer Plate x 4 ITEM 7 - Screw - M10 x 100mm x 4 ITEM 8 - Cover Cap - Black or White x 4 TOOLS/EQUIPMENT REQUIRED: - 6mm Allen Key (Supplied within kit) - Ø16mm Masonry Drill Bit - Appropriate Power Drill - Hammer - Appropriate Lubricant / Grease Spray Please also refer to the ‘Manual Handling Operations Regulations 1992’ during the handling of the product and materials used for installation. Glasdon recommends that a full Health and Safety analysis and site survey is carried out prior to installation. IMPORTANT NOTE: ENSURE THAT ALL RELEVANT PERSONNEL READ THESE INSTRUCTIONS PRIOR TO USE 1 of 4 1 DIAGRAM NOT TO SCALE 2 3 4 5 6 7 8 BOLT DOWN FIXING INSTRUCTIONS ALL DIMENSIONS IN MM