GLOBAL Export Import GS804 Manuals

CO ALARM USER’S MANUAL Model No: GS804 Thank you for purchasing the GS804 carbon monoxide alarm. Please take a few minutes to thoroughly read the user’s guide and familiarize yourself and your family with its operation. And save for future reference. Installation Instructions: Installation Location When choosing your installation locations, make sure you can hear the alarm from all sleeping areas. If you install only one carbon monoxide alarm in your home, install the alarm near bedrooms, not in the basement or furnace room. Caution This alarm must be mounted on a ceiling or wall. Mounting step Please refer to sketch map: picture 2 1: Mark the proper location on the wall or ceiling, according to the two holes of the bracket of alarm. 2: Drill two ф5.0mm holes in the ceiling or wall, then insert two plastic plugs into the holes. 3: Attach the bracket to the plastic plugs and fix tightly the screws into the plastic plugs. 4: Fit the alarm on the bracket and turn the alarm body clockwise, until matching well on the bracket. 5: After installing or replacing the battery, reinstall your alarm. Test your alarm by using the test button and check that the green LED flashing about every 30 seconds. As you install the battery on the unit, maybe it will sound for several minutes, then stop and enter normal operation mode. If it always sounds, please call our agent. Recommended Installation Locations: The following suggestions are intended to help you with the placement and installation of your alarm. 1: Place out of the reach for children. Under no circumstance should children be allowed to handle the alarm. 2: Install in a bedroom or hallway located close to the sleeping area. Take special care to verify the alarm can be heard in sleeping areas. 3: It is recommended that a alarm be installed on each level of a multilevel home. 4: Locate at least 5 feet away from all fuel burning appliances. 5: Placing at eye level allows for optimum monitoring of the red and green indicator lights. · 6: Insure that all vents of the unit are unobstructed. 7: Do not install in dead air spaces such as peaks of vaulted ceilings or gabled roofs. 8: Do not install in turbulent air from ceiling fans. 9: Do not place near fresh air vents or close to doors and windows that open to the outside. 10: Keep the alarm away from excessively dusty, dirty, or greasy areas such as kitchens, garages and furnace rooms. Dust, grease and household chemicals can affect the sensor. 11: Keep out of damp and humid areas such as the bath room. Avoid spraying aerosols near the alarm. 12: Do not install in areas where the temperature is below 4℃ or hotter than 38℃ 13: Do not place behind curtains or furniture. Carbon monoxide must be able to reach the sensor for the unit to accurately detect carbon monoxide. LED Indicator Light: 1: If a dangerous level of carbon monoxide is detected, the red alarm LED will flash continuously and the alarm will sound, until carbon monoxide is eliminated. 2: If battery failure or low battery is detected, the alarm will “chirp” one time and with a corresponding green LED flashing one time per 30 seconds.