GoFlight GF-RP48 Manuals

GF-RP48 MANUAL 2012 1 Virtual Pilot Operating Handbook GF-RP48 & RP-48 Mouse RP48/Pushbutton Panel Cockpit Control Module Congratulations on your purchase of the GoFlight GF-RP48 Rotary/Pushbutton Panel Module, part of the extensive Family of GoFlight Cockpit Control System modules. The GF-RP48 is designed to operate with a wide variety of aircraft and is sure to make your flight simulation experience more realistic and enjoyable. The steps below will assist in the installation, configuration, and operation of the GF-RP48. Following these instructions will help to get you up in the “virtual skies” as quickly as possible. NOTE: If you own other GoFlight hardware and have already installed the most current version of software on your system, you do not need to install the software again. Simply skip the software installation steps in the instructions below. Installing the GF-48 Rotary/Pushbutton Panel Module 1. Get on line and go to http://www.goflightinc.com. 2. On the home page click Support. 3. Click on “GF Config x.xx” to download our latest module drivers and configuration software. 4. Click “Run” or “Save” and follow the instructions to install the software. If the software installer detects that GoFlight software is already installed on your system, it will prompt you to overwrite. Click the Yes button to overwrite the existing version of GoFlight software. This is useful if you wish to keep the configuration settings for other GoFlight modules installed on your system. However, you should first make sure that the software you are overwriting is an older version and not a newer one. 5. If you are going to mount the GF-RP48 module into a GoFlight rack, install the module in any desired location in the rack using the thumbscrews provided. NOTE: When tightening the GF-RP48 mounting thumb screws, be careful not to over-tighten the screws as it is possible to strip the threads in the mounting holes or break the mounting screws if excessive force is applied.