Graco M5 Manuals

GENUINE GRACO PARTS AND ACCESSORIES Valve Repair Kit 240453 For EM5™, PM5™, LDM5 , LDP5 Electronic Metered Dispense Valves Important Safety Instructions Read all warnings and instructions in your meter operation manual. Save your instructions. 406390F NOTES: • Replace all parts • Use all parts in this kit 9. Push new valve stem assembly (16b) into valve seat (16e). 10. Install valve stem assembly, seat and spring (16) into the meter housing. Thread valve seat into meter hous- ing. Torque to 140-150 in-lb (15 to 17 N•m). Note: Be careful not to pinch spring when installing valve stem. 11. Install trigger on valve stem assembly. 12. Install meter housing and cover pieces together. Install six screws. Torque to 7 - 10 in-lbs (0.8 to 1.1 N•m). Filter Replacement 1. If not already done, follow Pressure Relief Procedure provided in meter instruction manual. 2. Unscrew the hose from the swivel (3). 3. Remove o–ring (27) and filter (25) from inside of the swivel with an o–ring pick. 4. Push the new filter (25) into the swivel. Verify it is properly seated. Orient the new filter (25) correctly, so the concave side of the screen faces downstream, as shown in illustrations on page 2 . Graco Inc. P.O. Box 1441 Minneapolis, MN 55440-1441 406390 Rev, F 07/2008 Copyright 1998, Graco Inc. is registered to I.S. EN ISO 9001 Service Instructions (Refer to EM5, PM5, LDM5 and LDP5 parts, page 2) 1. Follow Pressure Relief Procedure provided in meter instruction manual. 2. Remove six screws holding cover together and sepa- rate the two cover from the meter housing. 3. Remove trigger from valve stem assembly (16b). 4. Unscrew valve seat (16e) 5. Remove valve seat (16e) and valve stem (16b) assembly. 6. Pull valve stem (16b) out of valve seat (16e) assembly (16e). 7. Discard old valve stem assembly and spring (16a). 8. Apply lubricant to all new parts. Place new spring (16a) in new valve stem assembly (16b.