Hakko Electronics FR-860 Manuals

OUT1 OUT2 AL1 AL2 COM RDY DI MODE FUNC ▼▲ PV SV Controller Preheat plate (L) Power cord 1 1 1 PACKING LIST AND PART NAMES 1 1 Thermocouple Instruction manual WARNINGS AND CAUTIONS Warnings and cautions are placed at critical points in this manual to direct the operator's attention to significant items. They are definedas follows. WARNING : CAUTION : Failure to comply with a WARNING may result inserious injury or death. Failure to comply with a CAUTION may result in injury to the operator, or damage to the items involved. CAUTION When power is ON, the plate surface may be as hot as 500℉. To avoid injury or damage to personnel and items in the work area, observe the following : ● ● ● ● ● ● ● ● ● ● Do not touch the plate or place metal parts near the plate. Do not allow the plate to come close to, or touch, flammable materials. Inform others in the area that the unit is hot and should not be touched. Turn the power off when not in use, or left unattended. This product is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the product by a person responsible or their safety. Children should be supervised to ensure that they do not play with the product. Do not use the product for applications other than Preheat plate. Do not allow the product to become wet, or use it with wet hands. Remove power and controller cords by holding the plug - not the cord. While using the product, don't do anything which may cause bodily harm or physical damage. SPECIFICATIONS Output Power Consumption Temperature Range Temperature Stability Dimensions (Large plate) (Controller) Size of plate Weight (Without cord) AC120V 60Hz 600W (Large plate) 0-500℉ ±10℉ 250(W)×79(H)×204(D)mm (9.8×3.1×8.0 in) 100(W)×66(H)×169(D)mm (3.9×2.6×6.7 in) 178×178mm (Large plate) (7.0×7.0 in) 2.5kg (Large plate) (5.5 lbs.) 1.0kg (Controller) (2.2 lbs.) Controller To use the controller to configure the preheat plate for use as follow. Themocouple connector Setting temperature Toggle switch Plate temperature Power switch 1. Turn the power switch ON. 2. Setting temperature is displayed as Set Variable (SV). Plate temperature is displayed as Process Variable (PV). The plate temperature rises to the setting temperature. 3. When changing the setting temperature, press the “▼”button or “▲”button to set the temperature. 4. Turn the power switch OFF after using. *Toggle Switch The controller has toggle switch to select between plate temperature control or T/C temperature control. For T/C temperature control: 1. Insert thermocouple into thermocouple connector. Place the thermocouple end on a desired temprature measuring point or the item to be heated by the plate. 2. Switch toggle switch to T/C mode. 3. Temperature reading of the thermocouple is displayed as Process Variable. Change the setting temperature as needed. CAUTION When the thermocouple is attached, the temperature of the plate will rise until the T/C reaches to the setting temperature. Ensure the T/C is properly attached and not left in open air or damage may result. Controller Preheat plate Power cord Thermocouple OPERATION Instruction Manual Thank you for purchasing the HAKKO FR-860 preheat plate. Please read this manual before operating the Preheat plate. Keep this manual readily accessible for reference. PREHEAT PLATE FR-860