Heatilator CFL-18NG Manuals

1 LOG #1 & #2: (SRV481-766) Set logs #1 and 2 in front of the burner. Rest the bottom two notches over the extended material of the burner legs. Slide it towards the burner until it comes in contact with the burner. 481-925C 3/04 LOG #3 & #4: (SRV481-755) NOTE: An additional piece of INSULATION is shipped with your log set. If this piece is missing, DO NOT PROCEED. Call your deal- er. Following the instructions given below is very important (Flat spots will guide you throughout the process). Use the log num- bers to identify the logs. Check to make sure the tabs on the side of burner legs are bent outward. After setting burner, place insula- tion provided with log set beneath burner as- sembly and above valve. Make sure valve is totally covered. WARNING: Failure to do so will cause the unit to malfunction and create a potential dangerous situation. Set og grate by resting it down and sliding it toward burn- er. Make sure right and left grate bars slide on outside of burner legs between tabs. Place “dime size” pieces of mineral wool on the top of the burner, spaced dimes width apart. Set logs #3 and 4 between the grate and logs #1 and 2 with the bark detail towards the outside. Logs #3 and 4 should be even with logs #1 and 2 from one side to the other. Slide grate to hold log in place. 1 3 1 3 INSULATION 1 3 BRACKETS (For use to place log #5) LOG PLACEMENT INSTRUCTIONS Models: CFL-18NG/LP CFL-18NG/LP-B 2 4 5 6 7 8 9 10 4 4 2 2