Honeywell NOTIFIER ASY-01-044-NIM Manuals

1 1 Product Overview This Installation sheet describes how to mount and connect:  A Network Interface Module (NIM) to a Fire Panel The Network Interface Module stores data received from the Networks Cards. The stored data is accessed by the AFP-2800 and presented to the operator. NOTE: The Network Card is supplied separately. WARNING: Remove all power sources to equipment while connecting the components. Leave the external, main power breaker OFF until installation of the components are complete. 2 Installation 1. Unplug from the PSI board: a. The 27 Volt PSU Power Supply Cable running from the PSI board - see Connection Schematic. b. The 4 - Way Power Cable running from the Termination board - see Connection Schematic. c. The Battery Power Supply - see Connection Schematic. d. The 10 - Way Ribbon Cable running to the Termination board - see Connection Schematic. 9 Columbia Way Baulkham Hills, NSW 2153 PH 02-9894-1444 • FAX 02-9894-4193 www.notifier.com ASY-01-044 - NIM Product Installation Sheet DOC-03-061 ECN12-0032 28/06/2012 Rev: 1.00 2 2. Remove the 4 M3 x 8mm screws connecting the PSI mounting bracket to the Loop Interface Module (LIM) Figure 2-1: Removal of the M3 x 30mm Spacers, and the M3 x 20mm Spacers NOTE: Do not remove the M3 Screws connecting the PSI Mounting Bracket to the PSI board. 3 3. Replace the existing M3 x 20mm Spacers and the M3 x 30mm Spacers with 4 M3 x 25mm Spacers (#11171) Figure 2-2: Mounting NIM to LIM with M3 x 25mm Spacers 4. Replace the 40 - Way Ribbon Cable connected to the LIM ‘IN’ Port with the 100mm 40 - Way Ribbon Cable (#10202) - see Connection Schematic. 5. Connect: a. The 100mm 40-Way Ribbon Cable (#10202) to the NIM ‘OUT’ Port b. The 40-Way Ribbon Cable (#10200) to the Termination Board from the NIM ‘IN’ Port - see Connection Schematic. c. The C30 3-Way Wafer Cable (#10206) to the NIM 24V – 0V – 5V Port d. The loose end of the C30 3-Way Wafer Cable (#10206) to the Top Power Port on the Termination Board - see Connection Schematic. e. The NUP Cable (#11637) to the NIM NUP Port - see Connection Schematic. f. The loose end of the NUP Cable to the Network Card NUP Port. 6. Set the NIM Dip-switches to: 1 2 3 4 ON ON OFF OFF Table 1: NIM Dip-switch Settings 7. Position the NIM (#11628) over the M3 x 25mm Spacers (#11171). 8. Secure the NIM at the top (#11628) with 2 additional M3 x 25mm Spacers (#11171) 9. Secure the bottom of the NIM with the 2 M3 x 15mm Spacers (#11828) 4 10. Position the PSI board assembly over the M3 x 25mm Spacers (#11171) and the M3 x 15mm Spacers (#11828) 11. Secure the PSI mounting bracket to the bottom Spacers with 2 M3 x 8mm Screws (#2316) 12. Screw the top part of the PSI board to the top spacers with 2 M3 x 8mm Screws (#2316) Figure 2-3: Mounting PSI board to NIM