Honeywell T8011F Manuals

1 69-1431 OWNER’S GUIDE T8000C, T8001C, T8011R, T8024C Programmable Thermostats 69-1431

® U.S. Registered Trademark Copyright © 2001 Honeywell • •All Rights Reserved INSTALLATION INSTRUCTIONS 69-1558 T8011F Flush Mount Programmable Heat Pump Thermostat APPLICATION The T8011F Heat Pump Thermostat provides 24 Vac control of a two-stage heating and one-stage cooling heat pump system with manual changeover from heat to cool. First stage heating and cooling cycle rates are fixed at 3 cph. Second stage heating cycle rate is selectable 3, 6, 9, or 12 cph. Temperature indication can be set for °F or °C. The T8011F Heat Pump Thermostat is powered directly from the system transformer. Setpoints are held permanently in memory and retained during power outages. The T8011F model includes a thermostat, wallplate and Owner’s Guide. See Table 1. MERCURY NOTICE If this control is replacing a control that contains mercury in a sealed tube, do not place your old control in the trash. Dispose of it properly. Contact your local waste management authority for instructions regarding recycling and the proper disposal of the control. INSTALLATION When Installing this Product… 1. Read these instructions carefully. Failure to follow them could damage the product or cause a hazard- ous condition. 2. Check the ratings given in the instructions and on the product to make sure the product is suitable for your application. 3. Installer must be a trained, experienced service technician. 4. After installation is complete, check out product operation as provided in these instructions. CAUTION Hazardous Voltage. Can damage heating/cooling system. Disconnect power at furnace or main breaker/ fuse box. Location Install the thermostat about 5 ft (1.5m) above the floor in an area with good air circulation at average temperature. See Fig. 1. Do not install the thermostat where it can be affected by: — drafts or dead spots behind doors and in corners. — hot or cold air from ducts. — radiant heat from the sun or appliances. — concealed pipes and chimneys. — unheated (uncooled) areas such as an outside wall behind the thermostat. Installing Wallplate in Wall IMPORTANT Level only for appearance. The thermostat func- tions normally even when not level. Mount wallplate and the T8011F with the wing anchors provided (see Fig. 2) as follows: 1. Place the wallplate template at the desired location on the wall. 2. Trace and cutout the opening. 3. Pull the thermostat wire through the wallplate entrance hole. 4. Fasten the wallplate to the wall using the wing anchors. Table 1. Description of T8011F Thermostat. Model System Changeover System Selection Fan Selection Powering Method T8011F Heat Pump Manual Cool-Off-Heat-Em. Ht. Auto-On Hardwired

1 69-1557 OWNER’S GUIDE T8011F Flush Mount Programmable Heat PumpThermostat 69-1557