Human Touch PC410 Manuals

Tools Required: Ruler, Locktite, 5/16-inch Allen wrench, 10-mm wrench, pliers, small flat-head screwdriver. NOTE: This procedure can be completed by one person, although having a second person is helpful when installing the new backrest. SAVE ALL PARTS FOR USE DURING REASSEMBLY. 1. Remove the body pad and head pillow from the chair (for more information, see Use & Care manual). 2. Fully recline the chair. NOTE: If you cannot recline the chair using the recline lever, tip the chair gently on its side, then while using a flat-head screwdriver to push the brake tab toward the brake cable, manually move the chair to the fully reclined position. (Fig.10). 3. Using a 5/16” Allen wrench, remove the three Allen bolts located on the left-hand inner side panel (Fig.1). 4. Using a 5/16” Allen wrench, remove the four Allen bolts located on the underside of the left-hand armrest, which secure the armrest to the mounting plate (Fig.2). 5. Lift the left-hand armrest up to expose two bolts beneath it, then use a 5/16” Allen wrench to remove the two bolts, freeing the mounting plate from the chair. Turn the armrest upside down (Fig. 4). 6. Using your fingers, fold back the armrest upholstery on the underside of the armrest at the rear of the mounting plate to expose the cable end (Fig.5). 7. Locate the clamp on the underside of the armrest that secures the cable end, then use a wire cutter to split open the clamp, freeing the cable end. CAUTION: Be careful not to damage the cable (Fig.5). REMOVING THE BRAKE CABLE 1 SERVICE LEVEL: 3 June 28, 2016 REPLACING THE BRAKE CABLE PC-6/PC-410/PC-420 Allen bolt (Fig.2) (Fig.3) Cable Split open the clamp Clamp Mounting Plate (Fig.5) 2 Allen bolts front 2 Allen bolts back Allen wrench (Fig.1) (Fig.4) It is imperative that Human Touch® products are repaired in a manner that ensures product safety and regulatory compliance and that is fully consistent with the practices used during the manufacturing process. Therefore, Human Touch requires that all product repairs are performed using only factory-new parts and in accordance with these repair instructions. Failure to adhere to these instructions voids the product warranty and releases Human Touch from all liability for injury or product damage resulting from the repair.