HW Group Poseidon 3265 Manuals

Poseidon 3265 – starting guide HW group Oficjalny dystrybutor: www.atel.com.pl 45-231 Opole tel. +48 (77) 455 60 76 ATEL ELECTRONICS e-mail: [email protected] ul. Oleska 121 fax. +48 (77) 455 80 56 Starting Guide - Poseidon 3265 First steps for remote monitoring with Poseidon & GSM 1) Connecting Poseidon 3265   • Green POWER LED on RJ45 connector lights up – power supply is OK • Yellow LED on the RJ45 connector blinks – connection to 10 Mbit network is OK Accessories 600 165 Poseidon 3265 Poseidon model 3265 unit with 5 sensors and GSM modem support 600 313 Poseidon 3265 GSM2 Tset Start set - GSM modem, temperature sensors, power supply etc. 600 005 Temp-1Wire 3m Temperature probe, 3m connecting cable (1m=600 242,10m=600 056) 600 311 Temp-1Wire-Outdoor 3m Temperature probe for external use in food industry, cable 3m long 600 279 Humid-1Wire 3m Humidity probe, extending cable 3m long(1m= 600 278) 600 040 Poseidon T-Box Termination-Box for connecting up to 5 sensors, 10 cm long cable 600 280 Poseidon T-Box2 Termination-Box for connecting 2 sensors, 3m long cable Poseidon 3265 1.4) Connect temperature or humidity sensor to IT bus (Temp-1Wire or Humid-1Wire - RJ12 connector), the connector must click. 1.3) Connect power adapter to power supply (230 / 110V) and to power jack of Poseidon. The connector must be plugged in fully, green LED lights up. 1.1) Check DIP switches settings. For installation keep them as shown on the picture on the right (DIP1=Off, DIP2=Off). 1.2) RS-232 serial port for connecting GSM modem and setup purposes. 1.5) Connect Poseidon to Ethernet (use direct cable to Switch, cross-over cable to PC) GSM Modemcom G10 600 312 Poseidon T-Box 600 040 HTemp-Rack19 600 330 Temp-1Wire 1m 600 242 Humid-1Wire 3m 600 279