IBM Ultrastar 9LZX Manuals

IBM storage products Installation guide Ultrastar 9LZX & 18ZX Multi-mode SE/LVD Models: DRVS-09V DRVS-09D DRVS-18V DRVS-18D

Quick installation guide Ultrastar 9LZX & 18ZX Multi-mode SE/LVD Models: DRVS-09V DRVS-09D DRVS-18V DRVS-18D IBM storage products Page 1 IBM Hard Disk Drive Technical Support Center version 4.0 Handling precautions 1. Do not cover the breather hole! Covering the breather hole may result in loss of data. 2. Do not press on the drive! Do not apply any force to the drive during handling or installation. 3. Always handle the drive with care to prevent damage from shock, vibration, or electrostatic dis- charge (ESD). 4. Do not open the static-protective bag containing the drive until required. Static electricity can damage the drive. 5. Turn off and unplug your computer before removing the case. 6. When you are installing the drive, touch the static-protective package containing the drive to a grounded, unpainted metal surface for at least two seconds. (This drains static electricity from the package and from your body.) 7. Handle the drive carefully by the edges. Do not touch any exposed printed circuit board. 8. Save your drive packaging materials including the ESD bag in the event that the drive must be returned. Place the drive in an anti-static bag before placing it in the shipping container. The warranty will be void if the drive is not returned in IBM approved packaging. Quick installation procedure Backup all data before proceeding with the installation This procedure may require the use of a bootable System Diskette containing FDISK.COM and FORMAT.COM Setting the address 1. Each drive on the SCSI bus must have a unique address. Sixty eight and eighty pin (Wide SCSI) devices have 16 possible addresses. 2. SCSI address bits 3,2,1, and 0 of the 32 pin Option Jumper Block are used to select the SCSI device ID. 0 1 10 12 14 16 18 Ground Ground Termination Power Enable 1 3 5 7 11 13 15 17 19 21 23 25 27 29 31 2 4 6 8 20 22 24 26 28 30 32 +5V 2 SCSI ID Bits 3 Blank Ground External Activity LED Write Protect Auto Start Delay Disable Sync Negotiations Disable SCSI Parity Disable Unit Attention Auto Start Reserved Disable Wide Negotiations Ground Reserved Force Single Ended Mode Note: In the table below, “off” means a jumper is not in place and “on” means a jumper is in place. 15 on on on on 14 off on on on 13 on off on on 12 off off on on 11 on on off on 10 off on off on 9 on off off on 8 off off off on 7 on on on off 6 off on on off 5 on off on off 4 off off on off 3 on on off off 2 off on off off 1 on off off off 0 off off off off Address Bit 0 Bit 1 Bit 2 Bit 3