Industrial Scientific Ventis MX4 Manuals

MX4 External Battery Charger Adaptor User Guide Part Number: 17153953-1 Warnings and Cautionary Statements Hardware Overview Failure to perform certain procedures or note certain conditions may impair the performance of this product. For maximum safety and optimal performance, please read and follow the procedures and conditions listed below. Charging contacts Extended range battery cradle Li-ion battery pack charging surface Read all instructions before using the product. Do not touch battery contacts. Use in an area known to be nonhazardous. Capabilities and Compatibilities The MX4 External Battery Charger Adaptor can charge the MX4 Li-ion battery pack* or Li-ion extended range battery pack*. The charger adaptor is compatible with the following MX4 charger products*;  Single-unit Charger  Single-unit Charger/Datalink  Single-unit Automotive Charger, 12VDC, with Plug  Single-unit Truck-mount Charger, 12VDC, with Plug  Single-unit Truck-Mount Charger, 12VDC, Hard Wired  6-Unit Charger *Not included with the charger adaptor. Supplies Checklist Cradle latch Battery holder Charging contacts  MX4 Li-ion battery pack (not included) or MX4 Li-ion extended range battery pack (not included)  Charger (not included; Single-unit Charger shown)  Charger adaptor Instructions for Use See next page.

Industrial Scientific Ventis MX4: 4 Gas Meter

1 Multi-gas Monitor Product Manual Set-up Operation Service Part Number: 17152357-1 Version 15

Ventis™ MX4 Product Manual © 2011 Industrial Scientific Corporation 40 PUMP MODULE There are two field replaceable parts on the aspirated case: the water barrier and case top door. As needed, choose, read, and follow the appropriate instruction set(s). PUMP MODULE Pump Inlet Filter Cap and/or Water Barrier Replacement (if needed). 1 To remove the pump inlet filter cap, turn counter clockwise; set aside. 2 Remove the water barrier from inside the inlet. 3 To properly place the new water barrier, its bottom will come into contact with the pump inlet surface on which the barrier sits. The barrier’s bottom side has the smaller diameter opening in the black ring. 4 Re-place the pump inlet filter cap (or new cap); turn clockwise to tighten. Pump Door Removal and Replacement (if needed). 1 Loosen the single captive screw on the pump module door. 2 Slide the door down and lift. 3 The upper portion of the door has pegs on either side. The pegs fit into grooves where the door meets the module; they flex slightly for easy door removal. Angle the door so that one peg moves to the bottom of its groove and the other moves the top of its groove. Lift to unhinge the pegs and remove the door. 4 To properly place the new door, secure one of the pegs into its groove on the pump module. 5 Angle the door and press the other peg into its groove. 6 Close the door and slide up into place. 7 Tighten the single captive screw on the pump door.

Multi-gas Monitor Part Number: 17152355-1 Version 2 www.indsci.com Reference Guide A companion resource for the Ventis MX4 Product Manual