Inovonics EchoStream EN1235SF Manuals

© 2012 Inovonics - www.inovonics.com EchoStream® EN1235SF/EN1235DF Fixed Location Alarm Transmitter Installation Instructions - 05834C, January 24, 2012 1 Overview The Inovonics EN1235DF double button fixed location alarm transmitter and EN1235SF single button fixed location alarm transmitter feature a rugged design and housing and wall tamper protection. The EN1235DF and EN1235SF are designed for fixed position signaling. Note: For UL installations, refer to the EN4216MR Installation and Operation Manual, the EN4232MR Installation and Operation Manual, or the EN7285 Installation Instructions. 1.1 Inovonics Wireless Contact Information If you have any problems with this procedure, contact Inovonics Wireless technical services: • E-mail: [email protected] • Phone: (800) 782-2709 1.2 Transmitter Components Figure 1 Transmitter components 2 Installation and Startup 2.1 Installation Notes • These products are designed to be maintained by professional security technicians. • Products are intended for indoor use. • Manually test all products weekly. 2.2 Install/Replace the Battery 1. Insert a small screwdriver into the notch on the bottom of the transmitter, press the housing release tab, and, without twisting, lever the housing apart.. Figure 2 Open the Housing 2. If replacing a battery, remove the old battery. 3. Install the new battery. 4. Press the Reset button to initialize the transmitter. 2.3 Select the Frequency Band EchoStream products are able to use a range of radio frequencies, and must be configured for your geographic area. To configure the transmitter: 1. Place a selection jumper on the appropriate frequency band selection pins. • Leave the jumper off the pins to set the frequency range to 902-928 MHz for North America. • Place the jumper on the top two pins, marked AU, to set the frequency range to 915-928 MHz for Australia. • Place the jumper on the bottom two pins, marked NZ, to set the frequency range to 921-928 MHz for New Zealand. Note: Only devices set for use in North America are configured for UL installations. 2. Press the Reset button to complete configuration. Caution: When pressing the Reset button, make sure you don’t also touch the frequency band selection pins. Touching the frequency band selection pins while pressing the Reset button can inadvertently set the transmitter to the wrong frequency band. 2.4 Mount the Transmitter To operate correctly, the transmitter must be mounted. Caution: The transmitter must be mounted to operate correctly. If not mounted, the transmitter will remain in a tamper state. Caution: For UL installations, mount the EN1235DF/SF in a concealed area, where its operation cannot be viewed from a public space. To mount the transmitter: 1. Use the included hardware to mount the back plate of the transmitter housing to the mounting surface. 2. Hook the bottom of the transmitter into the back plate, then clip the top into place. A Reset button B Frequency band selection pins C Tamper switch B A C Lever Open the Housing Printing Instructions 1. Print duplex 2. Align and orient back page to match front page. 3. Cut on dashed line 4. Fold cutsheet in half along the 8.5" axis.