Intellian i3 Manuals

Intellian i3/i4/i4P Serial Number This serial number will be required for all troubleshooting or service calls made regarding this product. Notice All Right Reserved Intellian i3/i4/i4P® and Intellian® are the registered trademarks of Intellian Technologies, Inc., and should not be appropriated without permission by Intellian Technologies, Inc., and the information contained in this manual is the property of Intellian Technologies, Inc. Any and all parts of this manual shall not be reproduced and distributed in any form without prior written consent by Intellian Technologies, Inc. The information contained in this manual shall be subject to change at any time without notice due to the functional upgrades of the product. Copyright© Intellian Technologies, Inc. Doc. No. I3I4-DC V100

Copyright ® Intellian Technologies, Inc. Doc# : i3/i3L/i4/i4P/i5/i5P/i6/i6P/i6PE/i6W DCQ_2015_1103- V1.4 Intellian i3/i3L/i4/i4P/i5/i5P/i6/i6P/i6PE/i6W Quick Installation Guide 1. Select a location for the antenna. 2. Prepare the mount 3. Prepare the Antenna 4. Secure the Antenna 5. Connect the System Cables 6. Set Region (Nation/City) in ACU  Make sure nearby objects do not block the antenna.  Avoid unnecessary motion by locating the antenna as near as to the centerline of the boat.  Attach the installation template to the mounting surface using adhesive tape.  Remove the shaded center portion by using a hole saw.  Drill 4 bolt holes.  Open the antenna upper dome and remove the foam transit restraints from the antenna base.  Adjust the LNB Skew Angle (Linear Polarization Only). USA/Japan/Korea is not required to adjust.  Loosen screws of the connection of LNB and feed horn.  Tighten screws after adjusting the LNB position.  Connect the RF Cable from the RF 1 connector on the antenna to the ANT. RF1 connector on the rear of ACU.  Connect the ACU IRD Cable from the RECEIVER connector on the rear of the ACU to RF on the IRD.  Connect the power cable from the DC power connector on the rear of ACU to a power source of DC (10.8~15.6V). Note: i3L can only be connected to one receiver.  Turn on the ACU power and you will see USA DTV101 and DTV 119 as the default. The system functions will be abnormal if you do not set a correct continent and region.  Please select your region (Nation/City) after selecting the continent. Once the SET REGION has been done, you will not need to adjust GPS and the target tracking satellites. The setting steps as below.  Enter SETUP MODE and Press NEXT 13 times to enter LOAD REGION INFO menu.  Select CONTINENT and Press NEXT to select alternative continents.  Select REGION and Press NEXT to select alternative Nation/City.  Press YES to load the region setting.  Secure the antenna to the mount base using bolts, spring washers, and flat washers. Be sure to put the radome on while operating the system. The system functions will be abnormal if the radome is off. WARNING WARNING WARNING WARNING Antenna Unit 15° Obstacle

i3/i3L/i4/i4P Installation and operation User Manual Document Number: 2012EF-UM1004-V1_0