IXXAT CANio 500 Manuals

Quickstart Manual CANio 500 I/O-to-CAN Gateway English HMS Technology Center Ravensburg GmbH Helmut-Vetter-Straße 2 D-88213 Ravensburg Germany Tel.: +49 751 56146-0 Fax: +49 751 56146-29 Internet: www.hms-networks.com E-Mail: [email protected] Support In case of unsolvable problems with this product or other HMS products please fill in support form in the support are on www.ixxat.com. Further international support contacts can be found on our webpage www.ixxat.com Copyright Duplication (copying, printing, microfilm or other forms) and the electronic distribution of this document is only allowed with explicit permission of HMS Technology Center Ravensburg GmbH. HMS Technology Center Ravensburg GmbH reserves the right to change technical data without prior announcement. The general business conditions and the regulations of the license agreement do apply. All rights are reserved. Registered Trademarks All trademarks mentioned in this document and where applicable third party registered are absolutely subject to the conditions of each valid label right and the rights of particular registered proprietor. The absence of identification of a trademark does not automatically mean that it is not protected by trademark law. Document number: 4.01.0098.20000 Version: 1.3 Content Copyright IXXAT Automation GmbH 3 CANio 500 Quickstart Manual, version 1.3 1 General information ....................................................................... 5 1.1 Highlights ................................................................................ 5 1.2 Designs and device variants ................................................. 6 2 Connector assignments ................................................................. 6 2.1 Connector (X1) power supply 6-32 V DC .............................. 6 2.2 Connector (X2) CAN ............................................................... 7 2.3 Connector (X3) digital ............................................................ 7 2.4 Connector (X4) analog ........................................................... 9 3 LED displays ................................................................................... 9 3.1 PWR - LED .............................................................................. 9 3.2 CAN - LED ............................................................................. 10 3.3 USR 1/2 - LED ....................................................................... 10 4 Description of functions .............................................................. 10 4.1 Introduction .......................................................................... 10 4.2 Galvanic isolation ................................................................ 10 4.3 Digital outputs ...................................................................... 10 4.4 Digital inputs .......................................................................... 11 4.4.1 Digital inputs 1-4 .................................................................... 11 4.4.2 Additional digital input on connector (X1) .............................. 11 4.5 Analog outputs ...................................................................... 11 4.6 Analog inputs ....................................................................... 12 4.6.1 0 - 10 V input range ................................................................ 13 4.6.2 ±5V input range ...................................................................... 13 4.6.3 ±100 mA input range .............................................................. 14 4.7 Power supply PWR(+) .......................................................... 14 5 Software ........................................................................................ 15 5.1 CANio 500 as a CAN module ............................................... 16 5.1.1 CAN – Identifier ...................................................................... 16 5.1.2 CAN baudrate ........................................................................ 16 5.1.3 Node number ......................................................................... 16 5.1.4 Setting the digital outputs ....................................................... 16 5.1.5 Control of the analog outputs ................................................. 17 5.1.6 Digital inputs ........................................................................... 18