Keeler VIDEO VANTAGE Manuals

VIDEO VANTAGE USER INSTRUCTIONS Your Video Vantage is shipped aligned to the Vantage it is fitted to. The camera has an auxiliary lens in a ‘BLACK’ mount fitted over the camera lens. The lead to the camera is not connected. A video lead is not supplied. The power supply for the camera is 230 volts AC with a UK plug. Un-pack your Video Vantage and inspect for any signs of damage, if any is found please contact your dealer who you purchased this product from. SETTING UP 1) Locate and screw the camera lead to the top of the camera. 2) Locate and connect the camera lead into the socket marked ‘CAMERA’ on the front of the camera control box. 3) Connect the socket marked ‘VIDEO OUT’ on the rear of the camera control box to a suitable monitor. 4) Connect the camera power supply to the socket on the rear of the camera box marked ‘DC IN’. 5) Connect the camera power supply to a suitable power source, compatible to those marked on the power supply. 6) Connect the ‘VANTAGE’ to its own power supply. USING YOUR VIDEO VANTAGE BASIC CONTROLS The camera lens has a straight Knurled centre section (just above the auxiliary lens). This section alters the iris diameter, and is used to alter the brightness of the picture on the video monitor. If the picture is bright and bleached out close the iris down. If the picture is very dim and hard to see, open the iris up. At the bottom of the camera carrying frame just below the ‘PENTA PRISM’ is a black diamond knurled adjusting knob. This adjusting knob provides for a limited amount of tracking for the camera. This is so that the camera can be aligned to the position of the light patch produced by the VANTAGE. If the illumination mirror on the VANTAGE is rotated to raise the light patch, screw the adjusting knob clockwise to