Kenwood JKM075 Manuals

before using your Kenwood appliance ●Read these instructions carefully and retain for future reference. ●Remove all packaging and any labels. safety ●Always use the filter and never overfill - boiling water may splash out. ●Avoid contact with steam coming out of the spout area when pouring and out of the lid or spout area when refilling. ●Beware: the metal body of the kettle will get hot during operation. ●Never let the cord hang down where a child could grab it. ●Always unplug your kettle when not in use. ●Never put the kettle, cord or plug in liquid. ●Never use a damaged appliance. Get it checked or repaired: see ‘service’ ●Caution: Do not operate the kettle on an inclined surface. ●Make sure the lid is secure before switching the kettle on. ●Warning: Do not open the lid while the water is boiling. ●Take care when opening the lid - droplets of hot water may be ejected. ●Make sure the kettle is switched off before lifting or pouring. ●Unplug the kettle before filling or pouring. ●Never put the kettle near or on cooker hot plates or gas burners. ●This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. ●Children should be supervised to ensure that they do not play with the appliance. ●This kettle is for boiling water only. ●Only use the appliance for its intended domestic use. Kenwood will not accept any liability if the appliance is subject to improper use, or failure to comply with these instructions. before plugging in ●Make sure your electricity supply is the same as the one shown on the underside of your kettle. Important - UK only ●The wires in the cord are coloured as follows: Green and Yellow = Earth Blue = Neutral Brown = Live. ●The appliance must be protected by a 13A approved (BS1362) fuse. ●WARNING: THIS APPLIANCE MUST BE EARTHED. Note: ●For non-rewireable plugs the fuse cover MUST be refitted when replacing the fuse. If the fuse cover is lost then the plug must not be used until a replacement can be obtained. The correct fuse cover is identified by colour and a replacement may be obtained from your Kenwood Authorised Repairer (see Service). ●If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY. An electric shock hazard may arise if an unwanted non-rewireable plug is inadvertently inserted into a 13A socket outlet. ●This appliance conforms to EC directive 2004/108/EC on Electromagnetic Compatibility and EC regulation no. 1935/2004 of 27/10/2004 on materials intended for contact with food. before using for the first time 1 Fill to ‘MAX’, boil, then pour the water away. Repeat 2 to 3 times. key
hinged lid  lid release  on/off switch with indicator light  spout  filter  water level windows to use your kettle 1 Fill the kettle through either the spout or lid. To open the lid, push the lid release and pull the lid back . The water level must be between ‘MAX’ and ‘MIN’ (0.2L). ●Be economical: do not boil more water than you need. ●To improve the quality of your drinks always use fresh water. ●Empty the kettle after each use. 2 Check the lid is closed. 3 Plug in and switch on. The indicator light will come on. 4 Your kettle will boil and switch off automatically. To re-boil, wait a few seconds - the on/off switch needs time to reset. ●If you experience problems with your kettle switching on and off during use or switching off before boiling, check that the flat element is free from scale - see “descaling”. ●Your kettle is fitted with a filter to hold back limescale particles. ●If you find drops of water under your kettle, don’t worry - it is just condensation. boil-dry protection ●If you switch on with too little water, your kettle will cut out automatically. Switch off, unplug and let it cool down before re-filling. When it has cooled down, the switch will reset itself. care and cleaning ●Before cleaning, unplug your kettle and let it cool down. the outside ●Wipe with a damp cloth, then dry. Do not use abrasives - they will scratch the metal and plastic surfaces. the inside ●Even though your kettle comes with a filter, you still need to clean the inside (and the filter) regularly. the filter 1 Open the lid. 2 Unclip and slide out the filter . 3 either rinse under the tap or use a soft brush. or when descaling your kettle, drop the filter in too. Rinse thoroughly. 4 Replace the filter by locating the front of the filter into the spout area and then clip into place . descaling ●Regular descaling of the flat element will improve the performance of your kettle. If the kettle is not descaled regularly the build up of limescale may result in the following: ●problems may be experienced with the kettle switching on and off during use or switching off before boiling. ●the kettle may take longer to boil. ●the flat element may be damaged. Please note: Failure to descale your kettle may invalidate your guarantee. ●When limescale starts to build up on the heating element, buy a suitable descaler and descale your kettle. After descaling, boil with fresh water several times and discard. Clean any descaler off the kettle - it can damage the parts.       

English 2 - 5 Nederlands 6 - 10 Français 11 - 15 Deutsch 16 - 20 Italiano 21 - 25 Português 26 - 30 Español 31 - 34 Dansk 35 - 38 Svenska 39 - 42 Norsk 43 - 46 Suomi 47 - 50 Türkçe 51 - 54 Ïesky 55 - 58 Magyar 59 - 63 Polski 64 - 68 Ekkgmij� 69 - 73 Slovenčina 74 - 78 ´¸∂w 97 - 28 HEAD OFFICE: Kenwood Limited, 1-3 Kenwood Business Park, New Lane, Havant, Hampshire PO9 2NH 18343/6 instructions istruzioni instrucciones Bedienungsanleitungen gebruiksaanwijzing JKM075 JKM076

English 2 - 4 Nederlands 5 - 7 Français 8 - 10 Deutsch 11 - 13 Italiano 14 - 16 Português 17 - 19 Español 20 - 22 Dansk 23 - 25 Svenska 26 - 28 Norsk 29 - 31 Suomi 32 - 34 Türkçe 35 - 37 Ïesky 38 - 40 Magyar 41 - 43 Polski 44 - 46 Русский 47 - 50 Ekkgmij
51 - 54 Kenwood Limited, New Lane, Havant, Hampshire PO9 2NH, UK www.kenwoodworld.com 18343/3 JKM075 JKM076 ´¸∂w 55 - 57 UNFOLD

before using your Kenwood appliance ●Read these instructions carefully and retain for future reference. ●Remove all packaging and any labels. safety ●Always use the filter and never overfill - boiling water may splash out. ●Avoid contact with steam coming out of the spout area when pouring and out of the lid or spout area when refilling. ●Beware: the metal body of the kettle will get hot during operation. ●Never let the cord hang down where a child could grab it. ●Always unplug your kettle when not in use. ●Never put the kettle, cord or plug in liquid. ●Never use a damaged appliance. Get it checked or repaired: see ‘service’ ●Caution: Do not operate the kettle on an inclined surface. ●Make sure the lid is secure before switching the kettle on. ●Warning: Do not open the lid while the water is boiling. ●Take care when opening the lid - droplets of hot water may be ejected. ●Make sure the kettle is switched off before lifting or pouring. ●Unplug the kettle before filling or pouring. ●Never put the kettle near or on cooker hot plates or gas burners. ●This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. ●Children should be supervised to ensure that they do not play with the appliance. ●This kettle is for boiling water only. ●Only use the appliance for its intended domestic use. Kenwood will not accept any liability if the appliance is subject to improper use, or failure to comply with these instructions. before plugging in ●Make sure your electricity supply is the same as the one shown on the underside of your kettle. Important - UK only ●The wires in the cord are coloured as follows: Green and Yellow = Earth Blue = Neutral Brown = Live. ●The appliance must be protected by a 13A approved (BS1362) fuse. ●WARNING: THIS APPLIANCE MUST BE EARTHED. Note: ●For non-rewireable plugs the fuse cover MUST be refitted when replacing the fuse. If the fuse cover is lost then the plug must not be used until a replacement can be obtained. The correct fuse cover is identified by colour and a replacement may be obtained from your Kenwood Authorised Repairer (see Service). ●If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY. An electric shock hazard may arise if an unwanted non-rewireable plug is inadvertently inserted into a 13A socket outlet. ●This kettle complies with European Economic Community Directive 89/336/EEC. before using for the first time 1 Fill to ‘MAX’, boil, then pour the water away. Repeat 2 to 3 times. key
hinged lid  lid release  on/off switch with indicator light  spout  filter  water level windows to use your kettle 1 Fill the kettle through either the spout or lid. To open the lid, push the lid release and pull the lid back . The water level must be between ‘MAX’ and ‘MIN’ (0.2L). ●Be economical: do not boil more water than you need. ●To improve the quality of your drinks always use fresh water. ●Empty the kettle after each use. 2 Check the lid is closed. 3 Plug in and switch on. The indicator light will come on. 4 Your kettle will boil and switch off automatically. To re-boil, wait a few seconds - the on/off switch needs time to reset. ●If you experience problems with your kettle switching on and off during use or switching off before boiling, check that the flat element is free from scale - see “descaling”. ●Your kettle is fitted with a filter to hold back limescale particles. ●If you find drops of water under your kettle, don’t worry - it is just condensation. boil-dry protection ●If you switch on with too little water, your kettle will cut out automatically. Switch off, unplug and let it cool down before re-filling. When it has cooled down, the switch will reset itself. care and cleaning ●Before cleaning, unplug your ke and let it cool down. the outside ●Wipe with a damp cloth, then d Do not use abrasives - they wil scratch the metal and plastic surfaces. the inside ●Even though your kettle comes a filter, you still need to clean th inside (and the filter) regularly. the filter 1 Open the lid. 2 Unclip and slide out the filter  3 either rinse under the tap or u soft brush. or when descaling your kettle, the filter in too. Rinse thorough 4 Replace the filter by locating th front of the filter into the spout and then clip into place . descaling ●Regular descaling of the flat element will improve the performance of your kettle. If th kettle is not descaled regularly build up of limescale may resul the following: ●problems may be experience with the kettle switching on off during use or switching o before boiling. ●the kettle may take longer to ●the flat element may be damaged. Please note: Failure to descale yo kettle may invalidate your guarant ●When limescale starts to build on the heating element, buy a suitable descaler and descale y kettle. After descaling, boil with fresh water several times and discard. Clean any descaler off kettle - it can damage the parts ●Some regions of the country ha chalky water. This makes boiled water look cloudy and leaves a