Kingfisher KI2400 Series Manuals

Revision 6 Date: 20/4/2017 QUICK REFERENCE GUIDE KI2400/KI2800 Series Light Source Revision 6 Date: 20/4/2017 Quick Reference Guide – KI2400/KI2800 Light Source KI2400/KI2800 HAND HELD FIBER SOURCE, Manual operation • To remove interchangeable connector adaptor, press button on front of case and pull off adaptor. This may be easier with a test lead attached. • To turn on press [On/Off]. • To view firmware version, hold [F4] then press [On/Off]. • To view all display segments, press and hold[On/Off], [F1] at the same time until it stops beeping. • To defeat auto power-off, hold [On/Off] for 3 seconds at turn on until ‘Perm’ is displayed. • Low battery is indicated with a battery symbol. • To enter Source menu, press [Source]. • To return to Home menu, press [Home]. • To turn on back light press [ Backlight]. Source Menu: • Press [ - ] or [ + ] to select operating wavelength. • To change power level, press [F2] then use [ - ] or [ + ] (laser light source only, not available for LED sources). • To restore default power level, press [F2] then press [Toggle centre] (laser light source only, not available for LED sources). • To select modulation while source is on, press and release [Mode]. Press [Mode] again to select next available frequency or ID-tone. Alternatively, press and hold [Mode] then use [ - ] or [ + ] to cycle through all options. • To end modulation, press and hold [Mode] then press [Toggle centre]. Alternatively, press and hold [Mode] for 3 sec. Autotest Operation • To start Autotest press keys below on light source; For light sources with up to 4 : Press [AUTOTEST]. For light source with 5 or more : - press [Auto] to start Autotest for the default wavelength group (possibly “singlemode”). - hold [-] then press [Auto] to initiate Autotest for the other wavelength group (possibly “multimode”). • To check wavelength status, e.g. if it is selected for limited wavelength AutoTest, press [F4] while source is on. • To toggle selection of wavelengths for limited wavelength AutoTest, press and hold [Toggle centre] then press [F4] while source is on. • To start limited wavelength AutoTest, press and hold [Toggle centre], then press [Auto]. QUICK REFERENCE GUIDE: LIGHT SOURCE Change Records: Rev Date Editor Change description 6 20/4/2017 TO Ng Added instruction to view full segment of display & to view FW version (under 3 under Manual Operation section).