La Marche A48 Manuals

A48 INSTRUCTION MANUAL / ADJUSTMENTS / WARRANTY Page 1 of 8 A48 / A48B (base plate) BATTERY CHARGER ECN/DATE CPN41054 16816 – 6/05 15349-07-07/02 16041 – 6/03 14575-2/01 106 BRADROCK DRIVE DES PLAINES, IL. 60018-1967 (847) 299-1188 FAX: (847)299-3061 ISSUE DATE: 12315 - 8/98 INSTRUCTION DRAWING NUMBER: P25-LA48-1 A48 INSTRUCTION MANUAL / ADJUSTMENTS / WARRANTY Page 2 of 8 This manual contains important safety and operating instructions for the La Marche Power Conversion Equipment. Before using this equipment, read all instructions and cautionary markings on (1) unit, (2) battery, and (3) product using the battery. CAUTION: To reduce risk of injury and/or damage to the batteries, use only the type of batteries specified on the charger. Do not expose equipment to rain or snow. Do not operate equipment if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a qualified serviceman. Do not disassemble this unit; take it to a qualified serviceman when service or repair is required. Incorrect re-assembly may result in a risk of electric shock or fire. To reduce risk of electric shock, disconnect this unit from the AC supply, or batteries and loads before attempting any maintenance or cleaning. Turning off controls will not reduce this risk. WARNING – THERE IS A RISK OF EXPLOSIVE GASSES AND WORKING IN THE VICINITY OF A BATTERY IS DANGEROUS. SOME BATTERIES GENERATE EXPLOSIVE GASES DURING NORMAL BATTERY OPERATION. FOR THIS REASON, IT IS OF UTMOST IMPORTANCE THAT EACH TIME BEFORE USING THIS UNIT, YOU READ THIS MANUAL AND FOLLOW THE INSTRUCTIONS EXACTLY. To reduce risk of battery explosion, follow these instructions and those published by the battery manufacturer and manufacturer of any equipment you intend to use in the vicinity of the battery. Review cautionary marking on all products . PERSONAL PRECAUTIONS: 1. Someone should be within range of your voice or close enough to come to your aid when you work near a battery. 2. Have plenty of fresh water and soap nearby in case the battery electrolyte contacts skin, clothing, or eyes. 3. Wear complete eye protection and clothing protection. Avoid touching eyes while working near a battery. 4. If the battery electrolyte contacts skin or clothing, wash immediately with soap and water. If the electrolyte enters the eye, immediately flood the eye with running cold water for at least ten (10) minutes and get medical attention immediately. 5. Never smoke or allow a spark or flame in vicinity of a battery. 6. Be extra cautious, DO NOT drop metal onto a battery. It might spark or short-circuit the battery or cause an explosion. 7. Remove personal metal items such as rings, bracelets, necklaces, and watches when working with a battery. A battery can produce a short-circuit current high enough to weld these items causing severe burns. 8. NEVER charge a frozen battery. IMPORTANT SAFETY INSTRUCTIONS FOR THE LA MARCHE POWER CONVERSION EQUIPMENT SAVE THESE INSTRUCTIONS A48 INSTRUCTION MANUAL / ADJUSTMENTS / WARRANTY Page 3 of 8 PREPARING TO CHARGE 1. If it is necessary to remove the battery connections, always remove grounded the terminal from the battery first. Make sure all loads are disconnected and unit is off, so as not to cause an arc. 2. Be sure the area around the battery is well ventilated while the battery is being charged. 3. When cleaning battery terminals, be careful to keep corrosion from coming in contact with eyes. 4. Study all the battery manufacturer’s specific precautions such as removing or not removing cell caps while charging, recommended rates of charge, and maintenance procedures. UNIT LOCATION • Never place this unit directly above the standard flooded battery. Gases from the battery will corrode and damage equipment. A sealed maintenance free or valve regulated lead acid (VRLA) may be placed below this equipment. • Never allow the battery electrolyte to drip on this unit when reading the specific gravity or filling the battery. • Do not operate this unit in a closed-in area or restrict ventilation in any way. • Do not set any battery on top of this unit. DC CONNECTION PRECAUTIONS Connect and disconnect DC output cables only after setting all of this unit's switches to off position and removing AC input supply. GROUNDING INSTRUCTIONS This battery charger should be connected to a grounded, metal, permanent wiring system; or an equipment grounding conductor should be run with circuit conductors and connected to equipment- grounding terminal or lead on battery charger. Connections to battery should comply with all local codes and ordinances. CAUTION: DO NOT PULL ON OUTPUT CABLES WHEN DISCONNECTING CHARGER FROM BATTERY. A48 INSTRUCTION MANUAL / ADJUSTMENTS / WARRANTY Page 4 of 8 RECEIVING INSTRUCTIONS AND GENERAL EQUIPMENT INFORMATION CAUTION: To ensure safe installation and operation, the information given in the instruction manual should be read and understood before installing or using the equipment. RECEIVING INSTRUCTIONS Unpacking and Inspection: Examine the shipping crate upon arrival. If there is obvious damage, describe on the receiving documents. Within a few days after delivery, the equipment should be uncrated and carefully inspected for hidden damages. When removing packaging material, be careful not to discard any equipment, parts, or manuals. If any damage is detected you should: 1. File a claim with the carrier within five (5) days. 2. Send a copy of the claim to La Marche Mfg. Co. 3. Call La Marche Mfg. For a RETURN MATERIAL AUTHORIZATION NUMBER. Failure to properly file a claim for shipping damages, or provide a copy of the claim to La Marche Mfg., may void warranty service for any physical damages reported for repair. HANDLING WARNING: Equipment can be very heavy, and top-heavy. Use adequate manpower or equipment for handling. Until the equipment is securely mounted, care must be used to prevent the equipment from being accidentally tipped over. NOMENCLATURE PLATES Each piece of La Marche Mfg. Equipment shipped is identified by part number on the nomenclature plate. ADJUSTMENTS All equipment is shipped from the factory fully checked and adjusted. Do not make any adjustments unless the equipment has been powered-up and the settings have been determined to be incorrect. SPARE PARTS To minimize downtime during installation or normal service, it is advisable to purchase spare fuses, circuit boards and other recommended components. Please refer to the list of recommended spare parts and their La Marche Mfg. Part numbers included with the instruction manual. It is recommended that spare fuses be ordered for all systems. To order spare parts, please contact La Marche Mfg. (847)-299-1188 during business hours and ask for the Parts Department.