Lantronix DSTni-XPress DR Manuals

900-289 Rev B DSTni-XPress DR Quick Start DSTni-XPress DR/DR-IAP DSTni-XPress DR and DSTni-XPress DR-IAP are members of the Lantronix family of Device Servers. DSTni-XPress DR-IAP devices allow you to install the protocol suitable for your automation application. When you complete the setup, you can Ethernet-enable a serial device by connecting it to the serial port. (See the DSTni-XPress DR User Guide on the software CD.) Quick Connect Screw Terminals for RS-232 and RS-485/422 RJ45 Serial Port RS-232 & RS-422/485 RS-232 or RS-485/422 Select Switch Screw Terminals for 9-30VDC or 9-24VAC RJ45 10/100BASE-T Ethernet Port Status LEDs Reset Switch Transmit Active LED & Receive Active LED RESET 10/100BASE-T SERIAL RS232 RS485 F R A L Ethernet Serial 1. Connect the XPress DR to the network through the Ethernet port. (The unit must be on the same network as your computer.) 2. Connect power (9-30VDC or 9-24VAC). 19 20 21 22 GND GND 9-30VDC DC+ DC- 9-24VAC 3. Verify that the green Link LED is lit. Setup Follow these steps to quickly setup the device. Step 1: Start DeviceInstaller 1. Insert the software CD into your CD-ROM drive. When the main window appears, click the Device Installer button and follow the instructions on the screen. 2. Click the Start button, and then point to Programs. Point to the folder that contains Device Installer, then click Device Installer. The Device Installer main window will appear. Step 2: Assign an IP Address 1. Click the Assign IP icon. The Assign IP Address window displays. 2. In the Enter the Hardware or Ethernet Address field, type the Ethernet address (MAC address) listed on the Device Server label (on the right side of the unit). 3. In the Enter IP Address to assign field, type the IP address of the Device Server (xxx.xxx.xxx.xxx format). Select a PC Network Class. 4. Click the Set IP Address button. The Assign IP Successful message displays. Click OK. Step 3: Search the Network 1. Click the Search Network icon . The Search Network window displays. 2. Click the Start Search button. The message Response from xxx.xxx.xxx.xxx appears in the window. Click the Save button and a device saved message appears. Click OK then the Back button. The IP Address and Hardware Address appear in the window.