LCI Smart Jack Manuals

Smart Jack™ OEM INSTALLATION MANUAL Rev: 07.11.2018 Page 2 CCD-0001395 Introduction The Smart Jack™ features a high-efficiency motor, a new streamlined plastic shroud, and a new user interface. These features, along with the single power lead and the hitch height memory, give the end user a perfect reason to replace the traditional tongue jack with a far superior product. Safety Information Warning, Caution and Danger symbols indicate that an installation procedure has a safety risk involved and may cause death, serious injury or property damage if not performed safely and within the parameters set forth in this manual. Always wear eye protection when performing this installation procedure. Other safety equipment to consider would be hearing protection, gloves, and possibly a full face shield, depending on the nature of the installation procedure. TABLE OF CONTENTS Introduction 2 Product Information 2 Resources Required 2 Preparation 3 Installation 3 Operation 5 Setting Hitch Height Memory 5 Normal Operation 5 Return To Hitch Height Operation 5 Auto Retract 5 Resources Required • Cordless or electric drill or screw gun • Appropriate drive bits • 1/2" socket wrench Failure to act in accordance with the following may result in death, serious injury, trailer or property damage. Moving parts can pinch, crush, or cut. Keep clear at all times. Lifting the unit off of the ground so that the unit's wheels are not touching the ground will create an unstable and unsafe condition. Severe property damage, serious injury or death could occur. Keep people and pets clear of the unit and work area while operating the leveling system. Rev: 07.11.2018 Page 3 CCD-0001395 Installation Fig. 2 A B C Fig. 1 Footpad Power Tongue Jack Leg Clevis Pin Hairpin Cotter Pin Preparation 1. Make sure trailer is parked on level ground. 2. Chock all tires. 3. Support trailer according to OEM recommendations. 4. If necessary, remove footpad from the Smart Jack's Power Tongue Jack leg (Fig. 1). A. Remove hairpin cotter pin and clevis pin holding the footpad in place. B. Set the pins and footpad aside. 1. Carefully slide the jack leg (Fig. 2A) through the hole in the coupler (Fig. 2B) on the trailer A-frame (Fig. 2C). The trailer MUST be supported per OEM recommendations before working underneath. Failure to do so may result in death or serious injury.