LEGRAND Bticino HD4607/4 Manuals

Technical sheets

1 1 4 2 6 5 7 3 �� ��� � ��� �� ��� � ��� �� ��� � ��� �� ��� � ��� HD4607/4 HC4607/4 N4607/4 L4607/4 NT4607/4 AM5787/4 HS4607/4 Description This device is used to arm, disarm, and separate the zones of the system by placing a transponder badge (item 3530S and item 3540 previously stored in the central unit) in front of the zone transponder badge receiver. When used in an automation system it performs the control function for the management of scenarios. By pressing one of the pushbuttons, the corresponding zone is armed/disarmed. Within four seconds from the last pressure, the separation performed must be confirmed by moving a transponder saved in the central unit close to the device. Should this not take place, then the previous condition is automatically restored. Red LEDs on indicate that the zones are active, whereas red LEDs off show that they are disarmed. Configuration BURGLAR-ALARM mode: Since this item belongs to the activator group, it needs to be set up with the number of the “group” assigned and the progressive number of the devices in the “group”. It can also be programmed to perform Automation functions (scenario management). See Automation “MY HOME” guide for details. Z This configurator assigns the number of the appropriate zone (from 1 to 8) in the “group” of devices (any free zone in the system). To configure it as belonging to the activator group, no configurator must be inserted. N° This configurator assigns the progressive number within the group of activators. Configurator 1 identifies the first device, configurator 2 identifies the second, and so forth, up to a maximum of 9 activators (dividers, expanders or activators). NOTE: If all 9 permitted devices have already been assigned to the activator group, it could be possible to assign to configurator Z (zone it belongs to) a value between 1 and 9, taking into account the progressive number. MOD It assigns the modes of the audible signals (BEEP) and luminous signals (LED ON) provided by the divider when controlled by the transponder; it is used as a activators/ disconnector of the “Burglar-alarm” system. Technical data - Power supply from SCS BUS: 27 Vdc - Max. absorption: 15 mA - Operating temperature: 5 – 40°C Legend 1 - Transponder badge receiver zone; 2 - LED and pushbutton for controlling of zone 2; 3 - LED and pushbutton for controlling of zone 4; 4 - Indication “System ON/OFF”; 5 - Alarm warning; 6 - LED and pushbutton for controlling of zone 3; 7 - LED and pushbutton for controlling of zone 1. Dimensional data Size: 2 modules AUX Position not configurable for the “Burglar-alarm” function; configure only if it is necessary to enable the device for Automation functions (management of the scenarios stored in the unit or scenario module). Front view Z No. MOD AUX Clamp for burglar alarm BUS Rear view Central unit used Configurator value LED ON Enabling BEEP 3486 3485/B HD/HC/HS/L/N/ NT4601 none YES YES 1 NO YES 2 YES NO 3 NO NO L/N/NT4600/1 A/AM5780/1 4 YES YES 5 NO YES 6 YES NO 7 NO NO 1-4 zone transponder divider MQ00028-c-EN 24/04/2014