-
Similarities and Differences
2
-
COMBO can be used as a Washer or Dryer ONLY
3
-
• Turn the power OFF before servicing the COMBO.
11
-
The 2005 line-up of LG
12
-
• DIRECT DRIVE MOTOR
14
-
The recirculation pump circulates the water during
17
-
Heating Element Housing & Blower Assembly
21
-
RD&YL YL & BL BL & BL
22
-
Air Inlet to Tub (Temperature Control)
25
-
Blower Assembly Part#
27
-
DC Brushless -3 Pole Motor
28
-
Blower & Heater Duct Assembly
29
-
• Water inlet valve is energized approx. 80%
31
-
Inlet Valve Layout
34
-
Part # 4811ER3001A
35
-
BALL SENSOR is located Bottom Rear of Cabinet
36
-
TR (Sensing light)
37
-
Back of COMBO
38
-
Remove the shipping bolts
39
-
Install the COMBO on a firm, flat surface.
40
-
Connect the water hoses and the drain hose.
41
-
Program Chart (Washing)
43
-
The dispenser drawer is a multi-chambered
44
-
Use this flow chart
48
-
Diagnosis and Check List
54
-
continued on next slide
60
-
continued from previous slide
61
-
If still unstable, adjust the
63
-
Diagnosis – No Water Supply
64
-
Diagnosis – Detergent Does Not Dispense
65
-
Diagnosis – Other Products Do Not Dispense
66
-
Diagnosis – Abnormal Sound or Noise
67
-
Diagnosis – Heating w/out Water
68
-
Diagnosis – Drain Malfunction
69
-
Diagnosis – Wash Heater Malfunction
70
-
Diagnosis – Overheating Water
71
-
Diagnosis – No Circulation
73
-
Diagnosis – Spin Malfunction
74
-
Diagnosis – dE Error Code
75
-
Diagnosis – dHE Error Code
76
-
Diagnosis – Dryer Fan Malfunction
77
-
Diagnosis – Dryer Heater Malfunction
78
-
Remove the two screws on the
80
-
Remove the nine screws that
81
-
1. Disconnect the POWER
82
-
Remove the screw on the back.
83
-
4. Remove the clamp and the
84
-
Disconnect the electrical
85
-
Unplug the power connection
86
-
Remove the four screws
87
-
Remove the screw that was
88
-
Tilt out the cabinet cover.
89
-
Remove the gasket clamp
90
-
Open the door.
91
-
Repair – Motor
94
-
The Hall Effect sensor is
96
-
Remove the back cover.
98
-
The dampers (3) support the tub at the
99
-
Remove the bolts retaining
101
-
1. Remove the back cover.
102
-
3. Disconnect the electrical
103
-
7. Disconnect the drain hose on the
104
-
11.Remove the clamp
105
-
Remove the three dampers that
106
-
Open the spring clip on
107
-
Separate the tub halves to
108
-
Remove two bolts from
109
-
Repairing or replacing the
110
-
Repair – Water Level Switch
112
-
Remove the cabinet.
114
-
Remove the front cover.
115
-
The sensor assembly is bolted
119
-
1. Remove the clamp screw
122
-
5. Remove the two screws that
123
-
7. Release the clamp and
124
-
8. Leave the hose in the duct
125
-
DRUM and RELATED PARTS
130
