M-system R6N-RS2 Manuals

5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: [email protected] EM-7781-BK Rev.3 P. 1 / 4 INSTRUCTION MANUAL RTD INPUT MODULE, 2 points (Screw terminal) MODEL R6N-RS2 BEFORE USE .... Thank you for choosing M-System. Before use, please check contents of the package you received as outlined below. If you have any problems or questions with the product, please contact M-System’s Sales Office or representatives. ■ PACKAGE INCLUDES: RTD input module ...............................................................(1) ■ MODEL NO. Confirm Model No. marking on the product to be exactly what you ordered. ■ INSTRUCTION MANUAL This manual describes necessary points of caution when you use this product, including installation, connection and basic maintenance procedures. The unit is programmable using the PC Configurator Soft- ware. For detailed information on the PC configuration, refer to the R6CON users manual. The R6CON PC Con- figurator Software is downloadable at M-System’s web site: http://www.m-system.co.jp POINTS OF CAUTION ■ CONFORMITY WITH EU DIRECTIVES •�The equipment must be mounted inside a panel. •�Insert a noise filter for the input and communication line connected to the unit. NEC TOKIN Model ESD-SR-250 or equivalent is recommended. •�The actual installation environments such as panel con- figurations, connected devices, connected wires, may af- fect the protection level of this unit when it is integrated in a panel system. The user may have to review the CE requirements in regard to the whole system and employ additional protective measures to ensure the CE conform- ity. •�Install lightning surge protectors for those wires connect- ed to remote locations. ■ HOT INSERTION/REMOVAL OF MODULES •�Removing or replacing modules does not affect other mod- ules on the same backplane. It is possible to replace them without removing the power supply. However, replacing multiple modules at once may greatly change line voltage levels. We recommend that you replace them one by one. ■ GENERAL PRECAUTIONS •�Do NOT set the switches while the power is supplied. The switches are used only for maintenance without the power. ■ ENVIRONMENT •�Indoor use. •�When heavy dust or metal particles are present in the air, install the unit inside proper housing with sufficient ventilation. •�Do not install the unit where it is subjected to continuous vibration. Do not subject the unit to physical impact. •�Environmental temperature must be within -10 to +55°C (14 to 131°F) with relative humidity within 30 to 90% RH in order to ensure adequate life span and operation. ■ WIRING •�Do not install cables close to noise sources (relay drive cable, high frequency line, etc.). •�Do not bind these cables together with those in which noises are present. Do not install them in the same duct. ■ AND .... •�The unit is designed to function as soon as power is sup- plied, however, a warm up for 10 minutes is required for satisfying complete performance described in the data sheet. COMPONENT IDENTIFICATION Specifications Body Front Cover Mounting Adaptor INSTALLATION Mount the unit on the base (model: R6N-BS).