M-system R7L-DC16B Manuals

5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: [email protected] EM-7804-H Rev.7 P. 1 / 19 INSTRUCTION MANUAL PNP TRANSISTOR OUTPUT MODULE, 16 points (LONWORKS) MODEL R7L-DC16B BEFORE USE .... Thank you for choosing M-System. Before use, please check contents of the package you received as outlined below. If you have any problems or questions with the product, please contact M-System’s Sales Office or representatives. ■ PACKAGE INCLUDES: Transistor output module ..................................................(1) NeuronID label ...................................................................(2) ■ MODEL NO. Confirm Model No. marking on the product is exactly what you ordered. ■ INSTRUCTION MANUAL This manual describes necessary points of caution when you use this product, including installation, connection and basic maintenance procedures. LNS Plug-in Software (model: R7LPLG) is usable to set up Functional Blocks. For detailed information, refer to the R7PLG Users Manual. The R7LPLG is downloadable at M- System’s web site: http://www.m-system.co.jp POINTS OF CAUTION ■ POWER INPUT RATING & OPERATIONAL RANGE • Locate the power input rating marked on the product and confirm its operational range as indicated below: 24V AC rating: 24V ±10%, 50/60 Hz, approx. 80mA 24V DC rating: 24V ±10%, approx. 50mA ■ GENERAL PRECAUTIONS • Before you remove the unit or mount it, turn off the power supply and output signal for safety. ■ ENVIRONMENT • Indoor use. • When heavy dust or metal particles are present in the air, install the unit inside proper housing with sufficient ventilation. • Do not install the unit where it is subjected to continuous vibration. Do not subject the unit to physical impact. • Environmental temperature must be within -10 to +55°C (14 to 131°F) with relative humidity within 30 to 90% RH in order to ensure adequate life span and operation. ■ WIRING • Do not install cables close to noise sources (relay drive cable, high frequency line, etc.). • Do not bind these cables together with those in which noises are present. Do not install them in the same duct. ■ RESTRICTIONS WHEN USING LonMaker3.0 or 3.1 • Operating Environment Please use LonMaker3.0 under the Environment of LNS3 Service Pack 8 and use LonMaker3.1 under the Environ- ment of LonMaker3.1 Service Pack 3 or later. Please use resource files of LonMark Resource File Ver12 or later. • LNS Plug-in Software is not usable. • The network variable of nvoCNTOut (fbCNT) is only SNVT_count_f. • When registering a Device on LonMaker, please don’t use the following items. External Interface Definition / Upload From Device Specify Device Channel / Auto-Detect ■ AND .... • The unit is designed to function as soon as power is sup- plied, however, a warm up for 10 minutes is required for satisfying complete performance described in the data sheet.