McCall 1-1014F Manuals

McCall Refrigeration / 81 West Holly Street / Parsons, TN 38363 Phone (731) 847-5570 / Fax (731) 847-9012 / 1-888-REACH-IN (1-888-732-2446) / www.mccallrefrigeration.com January 2007 / Printed in U.S.A. BASE MOUNT FREEZERS ( 24" WIDE 1 SECTION ) Cabinet - Cabinets are all metal, inside and out. The top, back, and bottom are made of galvanized steel. In addition, all seams are closed and sealed, with metal edges turned away from the exposed surface. The result is an integrated structural frame. Internal corners are coved to conform to NSF standards. Automatic interior lighting is controlled by a light switch concealed in the door hinge. The cabinet is supported on four 6 inch adjustable steel legs. Doors - Constructed of metal, refrigerator doors are self- closing and fully insulated. Their cam-lift hinges are chrome-plated and self-lubricating. Hinges also have a safety stop that holds the door open, preventing overswing. Chrome-plated pull handles have built-in cylinder locks. The full-perimeter, magnetic vinyl gaskets are removable without the use of tools. Doors easily lift off, and door perimeters have a built-in, low wattage, and anti-condensate heater. Door openings are protected by an impact-resistant, nonconductive PVC breaker strip with no exposed screws or fasteners. Insulation - Cabinet body and doors are filled with pressure-injected polyurethane foam. Interior Shelves - Three wire shelves are standard. Shelves have a runner spaced 3/4 inch O.C. with two reinforcing bars 8 1/2 inch O.C. Coated with 7 mils of baked-on gray epoxy. The shelves have a saline spray corrosion resistance of 600 hours. Shelves will support 250 pounds each with maximum cabinet load of 800 lbs. They are supported on stainless steel pilasters, and are adjustable on 1 inch centers. All three shelves are interchangeable and can be adjusted without tools or special parts. Self-Contained Refrigeration - The condensing unit is bottom mounted behind a removable hatch cover. Components include a hermetically sealed compressor, receiver tank, and thermostatic temperature control. Thermostatic expansion valve and high-humidity evaporator coil is located inside the cabinet. Hot gas condensate evaporator is provided on self contained systems. The system is balanced to maintain 0°F average internal air temperature. All components are factory installed and tested and supplied with an attached cord and plug, except as noted. Remote Cabinets - are equipped for permanent connection. Standard remote units are provided with capped refrigeration lines, expansion valve, solenoid valve, electric condensate evaporator, and temperature control. Condensing unit is not included. All other features are the same as self-contained units. Model 1-1014F 1000 Series - Stainless steel interior and exterior. Standard Features • Bottom-mounted condensing unit • Expansion valve • Hot gas condensate evaporator • Cord and plug attached (115V only, less than 16 amps) • Interior thermometer • Self-closing doors with cam-lift hinges • Chrome-plated door handles with security locks • R-404A refrigerant Approval : AIA # ITEM # MODEL # PROJECT NAME SIS # SPECIFICATIONS 1-1014F CLASSIFIED TO NSF (STD-7-1999) McCall Refrigeration specification sheets are available online @ www.mccallrefrigeration.com