Miller Dynasty Series Manuals

Dynasty® Quick Reference DC TIG Setup Steel Alloys Stainless Steels Nickel Alloys Copper Alloys Titanium PURE TUNGSTEN (green) is NOT recommended! For best results use a sharpened cerium or lanthanum electrode when welding these alloys. Thorium Cerium Tungsten Selection See Tungsten Selection and Prep section. Press to Select Memory** Turn to Adjust Selected Parameter Press to View and Adjust Main Amps Tip: Select memory (if desired), then setup weld parameters from left to right. LEDs indicate Polarity, Process and Output. Select parameter above to view and adjust set value. Lanthanum * Feature only available on DX models. ** Feature only available on 350 and 700 models. Visit MillerWelds.com Recommended Setting DC TIG HF Impulse RMT STD OFF N/A PREFLOW**: 0.2 sec POSTFLOW: AUTO DIG: N/A N/A Feature Selection POLARITY PROCESS OUTPUT PULSER* SEQUENCER* GAS/DIG AC WAVESHAPE Notes Automatically sets output to DCEN Standard setup for high-frequency (HF) starts Standard setting for remote foot control Advanced control — see Pulsed TIG section Not used in RMT STD. Select RMT 2T Hold output to enable internal weld sequence control. Provides gas shielding before the arc start Automatically adjusts postflow time for maximum weld amps STICK welding function — NOT used for TIG AC TIG function — NOT used in DC AC TIG Setup Aluminum Magnesium PURE TUNGSTEN (green) is NOT recommended! For best results use a sharpened cerium or lanthanum electrode when welding these alloys. Cerium Tungsten Selection See Tungsten Selection and Prep section. Press to Select Memory** Turn to Adjust Selected Parameter Press to View and Adjust Main Amps LEDs indicate Polarity, Process and Output. Select parameter above to view and adjust set value. Lanthanum Recommended Setting AC TIG HF Impulse RMT STD OFF N/A PREFLOW**: 0.2 sec POSTFLOW: AUTO DIG: N/A EN/EP Amps** AC Balance AC Frequency Feature Selection POLARITY PROCESS OUTPUT PULSER* SEQUENCER* GAS/DIG AC WAVESHAPE Notes Automatically sets output to AC Standard setup for high-frequency (HF) starts Standard setting for remote foot control Advanced control — see Pulsed TIG section Not used in RMT STD. Select RMT 2T Hold output to enable internal weld sequence control. Provides gas shielding before the arc start Automatically adjusts postflow time for maximum weld amps STICK welding function — NOT used for TIG 1:1 Ratio 70–75% EN 120 Hz Note: Last procedure recall function stores settings for AC and DC welding in each memory level. Read and follow all labels and the Owner’s Manual carefully before installing, operating, or servicing unit. Read the safety information at the beginning of the manual and in each section. Note: These settings are intended to be a starting point for control panel setup — this is not a welding procedure specification nor a substitute for procedure qualification. See AC Waveshape section for complete descriptions. }