Nav TV NTV-KIT393 Manuals

Volt VIM Video in Motion for Chevrolet Volt NTV-KIT393 BHM 03/03/14 NTV-DOC104 3950 NW 120th Ave, Coral Springs, FL 33065 TEL 561-955-9770 FAX 561-955-9760 BHM 11/03/13 NTV-DOC104 Agreement: End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is intended for off-road use and passenger entertainment only. 2 | P a g e Overview The Volt VIM bypasses the factory lockout that inhibits the passenger from watching DVD video or inputting navigation destinations while the vehicle is in motion. The in-motion function is normally off, and is activated by the user whenever DVD video or navigation destinations need to be enabled. Kit Contents Volt VIM Module pin out Pin # Description Color 1 12v Constant (+) Yellow 2 Input 1 (12v VIM activation) Red 6 Cam Signal (Radio Side) Yellow 7 Camera Shield Yellow/Black 8 VSS (Radio Side) Brown 9 GM LAN (Radio Side) Green 10 Ground (-) Black 11 Reverse Signal White/Red 12 Output A (GPS Ant Break) White/Blue 13 Output B (ACC Power OUT) White/Purple 15 Front Cam Video IN Yellow (RCA) 16 Rear Cam Video IN Black (RCA) 17 VSS (Car Side) Blue 18 GM LAN (Car Side) Purple Volt VIM Module NTV-ASY192 Plug & Play T-Harness NTV-HAR185 GPS Antenna Extension NTV-CAB037 USB Cable (updates) NTV-CAB009 GPS Antenna Relay NTV-ASY165 Wire Side View BHM 11/03/13 NTV-DOC104 Agreement: End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is intended for off-road use and passenger entertainment only. 3 | P a g e GPS Antenna Relay Board *Note: The factory Navigation antenna will be dark blue. Volt Dash Disassembly 1. Remove the plastic trim ring around the shifter using a plastic pry tool. 2. Once removed, there are (2x) 7mm screws that must be removed.