Ness M1 Manuals

Solution-8 ×--«» í½ Í»°¬»³¾»® ïççì Û´»½¬®±²·½- Ü»-·¹² ú Ó¿²«º¿½¬«®·²¹ ïççìóïççë ß´´ ®·¹¸¬- ®»-»®ª ݱ²¬®±´ п²»´ © ݱ°§®·¹¸¬ øÓß èðð Ñ÷ www.msealarms.com.au

M1 & M1-G Cross Platform Controller User’S GUIDE This manual describes operation using KP1, KP2, KP3 keypads. The M1 Navigator touch screen keypad is covered separately. REV2

Ness M1 Z‐Wave Gateway Setup Guide Page 1 M1 Z‐Wave Gateway Setup Guide Revision 1.1 Introduction This setup guide will guide you through the steps on setting up the Ness M1 Z‐Wave Gateway. Hardware Required  M1XEP (Ethernet Module) with M1XEP firmware 2.0.42 or above. (101‐215)  M1 Z‐Wave Gateway (101‐296)  Computer  Active Internet connection Notes Ensure you are not connected with ElkRP after you have setup and programmed the M1. By being connected will stop all M1 protocols and the M1 Z‐Wave gateway will not communicate to the M1. Wait approx 1‐2 minutes after disconnecting from ElkRP before testing and using the M1 Z‐Wave Gateway.

Ness M1 Technical Document How to enrol a Proximity Fob into the M1 Page 1 Learning the Prox tag within the ‘Ness 4 Button Radio Key with Prox key’ (106-299) into a Ness M1 Panel Introduction This technical note will show you how to learn the Proximity tag that is within the Ness 4 Button radio key with Prox’ (Ness Part No 106-299) into an Ness M1 panel. Things to know before you begin You will need to have a Proximity reader connected to a Ness M1 Keypad (KP2 or KP3) and ideally have ELKRP connected to the M1. You cannot learn a Proximity tag directly into a Single door Access Module (101-246). Therefore if you only have a Single Door access module on the project you will need to temporarily connect a proximity reader to the back of the keypad. The following diagram, as supplied in the Installation manual of the KP2 or KP3 keypad shows how to connect the proximity reader to the reader.







Note: you will need a 2 Wire Wiegand cable (Ness Part No. 450-212) to connect the reader to the keypad to connect a Proximity Reader (e.g. 101-014) to enrol the Proximity Fob. . You will also need to know what spare M1 User Slot you have available to learn the Proximity tag to.

Ness Document No. 890-421 Ness M1 Navigator Touchscreen Keypad USERS MANUAL