Optimus AER-60T Manuals

3 Outdoor SPEAKER UNDERPOWERING VS. OVERPOWERING TECHNIAL SPECIFICATIONS LEFT RIGHT 2-CHANNEL AMPLIFIER WITH 8Ω OUTPUT 2 SPEAKERS PER CHANNEL CONNECTED IN PARALLEL 8Ω Observe correct Polarity for maximum Bass performance INSTALLATION INSTRUCTIONS User Manual Product code: A130RM Model code: AER-60T 8Ω Transformer tapes Model Frequency Resp(-10dB)(Hz) Sensititivy(1W/1M)(dB) Impedance(ohm) RMS power(watts) Peak power(watts) Enclosure material Environment Product Dimensions(mm) AER-60T 60-20K 88 8 80 70 LLDPE 440x300x300 IP56 70V:64-32-16-8-4-2W & 8ohms 100V:64-32-16-8-4W & 8ohms 2 1 Thank you for buying outdoor speaker. Please read and have a thorough understanding of the entire manual before installation and use. Keep the manual for maintenance. Introduction •Most speaker damage is caused by amplifiers with too little power (wattage). •An overdriven amplifier clips the waveforms and sends distortion to the speakers. •Clipping is usually audible; it may vary from a harsh sound to a fuzzy or unclear sound. •If you hear this condition at loud volume levels, turn down the volume until the distortion is no longer present. •Damage caused by operating the speakers at distorted volume levels is not covered by the warranty. EXAMPLE OF 70V/100V SYSTEM CONFIGURATION 70V/100V C 5 SPEAKERS CONNECTED IN PARALLEL USING 16W TAPS NOTE: The total number of speakers multiplied by the tap value cannot exceed the output power (in watts) of the 70V /100V amplifier. The above example shows 5 total speakers. Using the 16W taps, you will need an amplifier with at least (5) x (16) = 80W. A good rule of thumb is to select an amplifier with 20% greater power; in this case, an amplifier that delivers about 100W. UNDERPOWERING VS. OVERPOWERING IMPORTANT: Optimus has made every effort to provide accurate and detailed instruction for this product’s assembly and installation. Should you have any doubts consult a qualified professional fitter, Optimus recognizes no liability for any difficulty or problem derived from the interpretation of these instructions. These brackets and all their parts and accessories must only be used for the purpose they have been constructed. Optimus, its commercial distributors and retailers are not , directly or indirectly, responsible for any damage to persons and or properties derived from the use of this product in an unsafe or different way for which it has been designed and constructed. Several parts of this product are small pieces of hardware therefore extreme care should be taken to keep them from children. Read these instructions carefully before using the product 1. When the speakers are installed outdoor, check that the wall structure is reliable and that the speaker is firmly attached. The user should be responsible for this very thing. 2. Do not place the speakers on a turntable or movable support. 3. Do not touch or bump the woofer and tweeter. If these are damaged, the sound will be distorted. 4. Do not listen to sound at a very high level when you are changing the input source (for example, to tune FM / CD) installation or removal of cables should make sure that the power amp / amplifier device radio is turned off. 5. Don’t attempt to clean the speakers with chemical solvents as this may damage the paint surface. Clean with a dry cloth. Connection Use wire on the back of the speaker in the output tab of the amplifier (or amplifiers of radio). The speaker wire is on one side red and on the other one black. Connect to the red side of the amplifier and speakers (+) tab. Connect one end of the black side (-) in the other tab. Connect each speaker to make sure that is not (+,-) inverted polarity. If the polarity of the speakers is reversed, the sound will be unnatural and will play without bass. Depending on the type of installation, direct burial of the speaker wires from the amplifier to the loudspeakers may be adequate, or the use of 12 ID conduit may be required for protecting the wires from possible physical damage if future excavation or other alterations are anticipated in the area of the installation. Direct Burial Wire or Conduit AER-60T BLUE------ 8 WATTS 100V GREEN---8 WATTS 70V 16 WATTS 100V YELLOW- 16 WATTS 70V 32 WATTS 100V ORANGE-32 WATTS 70V 64 WATTS 100V BROWN---64 WATTS 70V NO 100V 4 WATTS 70V