Orion 8450 Manuals

INSTRUCTION MANUAL IN 106 Rev. D 02/09 Orion Illuminated Reticle Eyepieces #8450 12.5 Plössl #8496 5mm Ultrascopic An Orion Illuminated Reticle Eyepiece is useful for a variety of different applications in amateur astronomy. By virtue of its LED-lit crosshair reticle pattern, the illuminated reticle eye- piece aids in polar alignment of a telescope on an equatorial mount and in alignment of a telescope’s finder scope. It also allows precision guiding during long-exposure astrophotogra- phy when used with an off-axis guider or as the eyepiece in a guide scope. All Orion illuminated reticle eyepieces feature a double crossline reticle etched in optical glass (Figure 1). The double line arrangement allows conve- nient and precise positioning of a star image either in the tiny central square formed by the lines or on the intersection of any two of the lines. Attaching the Illuminator All models come with a wireless illuminator. To attach the illu- minator to the eyepiece, simply thread the LED end into the threaded hole in the side of the eyepiece. Turn on the illumina- tor by rotating the knurled knob on the exposed end of the illu- minator. Brightness is also controlled by the knurled knob. Be sure to turn the illuminator off when it is not in use, otherwise the batteries will drain unnecessarily. Yes, It’s Dim! Your first look through the eyepiece is likely to be in the day- time, and you might not be able to see the illumination of the double crosslines. When your eyes are dark-adapted, however, the illumination will be obvious. You should be able to see the LED itself light up even in the daytime when the illuminator is not coupled to the eyepiece. When using an illuminated reticle eyepiece in the field, the illu- mination should be set as dim as possible so faint stars in the field of view will not be “washed out” in the crosshairs’ glare. In some cases, you may find the illumination is too bright even at the dimmest setting. To diminish the brightness even further, try wadding up a tiny bit of paper and placing it between the eyepiece and the illuminator. While this may sound odd, it is a technique that has been employed by astrophotographers for many decades! Focusing the Eyepiece The knurled top of the eyepiece allows focusing of the double- crossline reticle to your eyesight. Proper focusing of the reticle is important. If it is not in focus, you may experience “parallax” errors in which the crosslines may appear to shift with respect to the sky background. It’s a good idea to focus the reticle with the main telescope capped or purposely set out of focus. Then, when the crosslines appear sharp, remove the cap from the telescope and look into the eyepiece. Aim at a star and focus the star image using the telescope’s focuser. Now, both the main telescope and the ret- icle itself should be in sharp focus in eyepiece’s field of view. Replacing or Installing Batteries The illuminator for the #8450 takes three SR54 batteries. These are common watch-type batteries that are widely available. The batteries are installed inside the illuminator arm. To replace the batteries, refer to Figure 2. Note that the positive (+) side of the batteries should face the LED end of the illuminator. The illuminator for the #8496 takes two SR44 batteries. These are common watch-type batteries that are widely available. The batteries are installed inside the illuminator arm. To replace the batteries, refer to Figure 3. Note that the negative (-) side of the batteries should face the LED end of the illuminator. Figure 2 Figure 1 Figure 3