Panasonic VL-SWD273 Manuals

Model No. Installation Guide Model Name Model No. VL-SV71 Video Intercom System VL-SV72 Main Monitor Station R This guide is for use with the above 4 models. Door station Main monitor station R The Installation Guide in Indonesian can be accessed from the following site: https://panasonic.net/cns/pcc/support/intercom/sv71 R Door station is described as "doorphone" and Main monitor station is described as "main monitor" in this guide. R In this guide, the suffix of each model number (e.g., the "BX" in "VL-SV71BX") is omitted unless necessary. Note to the installer R Before attempting to connect or operate this product, please read the label on the rear of the doorphone and the main monitor/extension monitor. R Please read this guide carefully, and install the product safely and correctly by following the instructions. Carefully read the information found in the section titled "For your safety" in particular. R Only use attachments/accessories specified by the manufacturer. R The installation shall be carried out in accordance with all applicable installation rules. R To the maximum extent permitted by law, Panasonic assumes no responsibility for injuries or property damage resulting from failures arising out of improper installation or operation inconsistent with this document. R After installation, make sure to leave this guide with the customer. VL-MV71 VL-MV72

Operating Instructions Wireless Video Intercom System Model No. VL-SWD501EX VL-SWD501UEX Important Information and Quick Guide For further information about features and operations, visit our Web site and find the document: https://panasonic.net/cns/pcc/support/intercom/swd273 Installation Guide is supplied separately. This system is an auxiliary system; it is not designed to provide complete protection from property loss. Panasonic will not be held responsible in the event that property loss occurs while this system is in operation. Thank you for purchasing a Panasonic product. Please read this document before using the product and save it for future reference. Carefully read the information found in the section titled "For your safety" in particular. VL-MWD273 VL-SWD273 VL-SVD273 Model Name Model No. Video Intercom System Wireless Video Intercom System Main Monitor Station Table of Contents 1. Introduction 2. Important information 4. Basic operations 6. VL-V900 basic operations 7. Other information 3. Preparation 5. Additional functions 15 13 12 11 8 5 2

Model No. Installation Guide Model Name Model No. Wireless Video Intercom System VL-SWD273 Video Intercom System VL-SVD273 Main Monitor Station VL-MWD273 R This guide is for use with the above 3 models. VL-V554 VL-MWD273 Door station Main monitor station R The Installation Guide in Indonesian can be accessed from the following site: https://panasonic.net/cns/pcc/support/intercom/swd273 R Door station is described as "doorphone" and Main monitor station is described as "main monitor" in this guide. R In this guide, the suffix of each model number (e.g., the "BX" in "VL-MWD273BX") is omitted unless necessary. Note to the installer R Before attempting to connect or operate this product, please read the label on the rear of the doorphone and the main monitor/extension monitor. R Please read this guide carefully, and install the product safely and correctly by following the instructions. Carefully read the information found in the section titled "For your safety" in particular. R Only use attachments/accessories specified by the manufacturer. R The installation shall be carried out in accordance with all applicable installation rules. R R After installation, make sure to leave this guide with the customer. To the maximum extent permitted by law, Panasonic assumes no responsibility for injuries or property damage resulting from failures arising out of improper installation or operation inconsistent with this document.

Key Features • Highly Expandable: Up to 6 additional monitors can be connected to the main monitor using a combination of 7-inch wired monitors and 2.2-inch wireless monitors (However, the maximum possible number of 7-inch wired monitors is 3). In addition, PBX connectivity is also supported. • Wireless Monitor: Using the wireless monitor, check visitors and respond promptly from the living room, kitchen and elsewhere in the home even while you are doing something else. Up to 6 wireless monitors connectable. Max wireless range is 100 m with no obstacles. You can add on repeaters to expand the range. Up to 2 DECT repeaters connectable. • 7-inch Screen: The main monitor and extension monitor have a 7-inch wide screen that offers easy viewing of wide vertical and horizontal views. • Voice Change Function: This function makes woman’s voice (higher keys) sounds like a man’s (lower keys). • Electric Lock Release Support for Gate: The gate or door lock can be easily and quickly released using monitors (wired or wireless) from anywhere in the house. • Wide-Angle Camera: Wide-angle lens covers approximately 170 degrees horizontally and 115 degrees vertically. • Picture Recording Function: The main monitor and extension monitor can record doorphone images from up to 50 doorphone calls or monitoring sessions. (up to 8 still images per visitor/session) • Night Vision with LED lights (illumination lamp): Door station is equipped with LED lights (illumination lamp). It enables the colour display of visitors at a distance of about 50 cm at night. Wiring Schematic Diagram Optional Accessories Wire type and length VL-SVD273: Wireless monitors sold separately Wiring run Wire type *6 Diameter Length (Max.) Doorphone – Main monitor – Extension monitor *7 φ 0.65 mm 22 AWG 100 m φ 1.0 mm 18 AWG 130 m φ 0.5 mm CAT 5 50 m Main monitor – Power supply unit φ 0.65 mm 22 AWG 10 m φ 1.0 mm 18 AWG 20 m Power supply unit – AC power source φ 1.2 mm - φ 2.0 mm (17 AWG - 12 AWG) No requirement Main monitor – Electric lock *8 φ 0.5 mm - φ 1.2 mm (24 AWG - 17 AWG) According to the specification of connected device. Doorphone – Electric lock *8 φ 0.5 mm - φ 1.2 mm (24 AWG - 17 AWG) According to the specification of connected device. Main monitor – Connection device for option input (A contact) *8 φ 0.5 mm - φ 1.2 mm (24 AWG - 17 AWG) According to the specification of connected device. Main monitor – PBX φ 0.65 mm CAT 3 or 22 AWG 100 m *1 When you use an additional doorphone, the maximum number of the electric locks that can be connected to the doorphone depends on the type of doorphone. Consult your dealer for further information. For VL-V554 users: - Make sure to only connect electric door locks to the S1/S2 terminals of the doorphones. *2 You can also connect an optional lobby station or Video Intercom System for Apartment Complexes. *3 Connection devices for option input (A contact) can be used when a VL-V900 and VL-V700 series Video Intercom System for Apartment Complexes is used. - Make sure to connect emergency terminals to the IN1/IN2 terminals. - Make sure to connect doorbells to the IN3/IN4 terminals. A doorbell and doorphone 2 cannot be used together. *4 VL-MWD273BX/VL-MWD273ML models only *5 VL-SWD273AZ/VL-SVD273AZ/VL-MWD273AZ: Use only the supplied AC cable. *6 Type: Single-pair cable with outer sheath (jacket) Conductor: Copper solid • A certified power supply wiring has to be used with this equipment. The relevant national installation and/or equipment regulations shall be considered. A certified power supply wiring not lighter than ordinary polyvinyl chloride flexible wiring according to IEC 60227 shall be used. *7 When an extension monitor is used, make sure that the total wiring length from the doorphone to the main monitor and then to the extension monitor, is within about 100 m. *8 When using an electric lock or a connection device for option input (A contact), select a device that meets the following guidelines: • Electric lock connection terminal (S1/S2, S3/S4): - N/O dry closure contact - 30 V AC (1 A)/24 V DC (1 A) or lower • Connection device for option input (A contact) terminal (IN1/IN2/IN3/IN4): - Input method: No-voltage contact - Open-circuit voltage between terminals: DC 7 V or less - Detection definite time: 0.1 seconds or more - Short-circuit between terminals: 5 mA or less - Resistance value: make: 500 Ω or less, break: 15 KΩ or more Door Station (Doorphone) VL-V522L (Surface mount) D1D2 S1 S2 D1 D2 D3 D4 Ml-1 Ml-2 MO-1 MO-2 MO-3 MO-4 MO-5 MO-6 IN1 IN2 IN3 IN4 P1 P2 1 2 3 4 19 20 21 22 5 6 7 8 9 10 11 12 13 14 15 16 17 18 S1 S2 S3 S4 Ml-1 Ml-2 5 6 Ml-1 Ml-2 5 6 Ml-1 Ml-2 5 6 NP NP NP NP NP NP NP NP NP NP D1D2 S1 S2 24 V DC NP 220-240 V AC *5 *2 *4 MAIN MONITOR EXTENSION MONITOR 1 EXTENSION MONITOR 2 EXTENSION MONITOR 3 Connection device for option input (A contact) *3 DOORPHONE 1 *1 DOORPHONE 2 *1 Terminal box (4-conductor wiring) PBX NP: Non-polarised Electric lock Electric lock Electric lock Power supply Power supply Power supply Power supply Electric lock VL-SWD273 VL-SVD273 Wireless Video Intercom System Door Station (Doorphone) CMOS 0.3 M pixels VL-V555 (Surface mount) CMOS 1.0 M pixels VL-V554 (Surface mount) VL-V554U (Flash mount) DECT Repeater VL-FKD2 Lobby Station Up to 20 main monitors can be connected. Wireless Monitor Station (Sub monitor) VL-WD613 Extension Monitor POWER SUPPLY UNIT (Power source) VL-MWD273: 24 V DC Power supply unit (supplied) VL-MWD272: 220-240 V AC, 50/60 Hz VL-MWD273 VL-MWD272