Paradox SR130 Manuals

Upgrading Firmware Upgrade SR130 firmware through the Paradox In-Field software (V3.0 or higher) using the 307 USB Direct Connect Interface. The SR130 requires the batteries installed in order to upgrade the firmware. Note: Ensure that the SR130 is awake before beginning the firmware upgrade. To wake-up the siren, press the training/reset switch (see connector #4 in Figure 1). The siren provide yous a 60 second delay in order to begin the update. 1. Remove the front cover (see Figure 2). 2. Connect the 307 USB to the In-Field connector (see connector #8 in Figure 1). 3. Upgrade according to the firmware upgrade instructions: Go to www.paradox.com >Software > In-Field Firmware Upgrade Instructions. Tamper Supervision If a tamper is detected, the SR130 sounds an alarm and the strobe light flashes for 4 minutes. The control panel follows the global supervision options set in the panel. Specifications Certifications Warranty For complete warranty information on this product, please refer to the Limited Warranty Statement found on the Statement. Your use of the Paradox product signifies your acceptance of all warranty terms and conditions. Please ensure that your use of the Paradox product is in compliance with local, national, and international laws. © 2015 Paradox Security Systems (Bahamas) Ltd. All rights reserved. Specifications may change without prior notice. US, Canadian and international patents may apply. BabyWare and Paradox are a trademarks or registered trademarks of Paradox Security Systems (Bahamas) Ltd. or its affiliates in Canada, the United States and/or other countries. SR130 Outdoor Wireless Siren w/Built-In Strobe Light SR130-EI01 Version 1.1 Printed in Canada 04/2015 Overview The SR130 is a stand-alone, fully supervised outdoor wireless siren with built-in strobe light and wireless transceiver. The SR130 uses 2-way wireless communication, which provides continuous supervision between the panel and siren with fast response to alarm signals within four seconds With normal use, the SR130 will function up to three years without the need to replace the batteries. The SR130 operates using three 1.5VDC size “C” alkaline batteries. This guide describes how to install and configure the SR130 wireless siren. SR130 I/Os and Connectors Figure 1: SR130 I/Os and Connectors Specification Description Power Supply 3x 1.5VDC “C” alkaline batteries. Battery life Up to 3 years based on normal use (e.g. 2 alarms per year with strobe for 2.5 hours and 8 squawks per day at an average of 25ºC (77ºF) with default alarm time set to 4 minutes. If the alarm is set for more than 4 minutes, the battery life may be reduced). Battery Low Voltage Signal Signal sent at 4.1 VDC RF frequency 433MHz or 868MHz RF range Up to 70m (230 ft) Siren 100dBA or more (1 meter) Humidity Range 5% to 90% Dimensions 13.43cm X 21.17cm X 5.1cm (5.29in X 8.34in X 2.01in) Weight 365g /12.87oz., 567g/20 oz. with batteries CE EN 50131-4 Grade 2 EN 50130-5 Class IV 1. Siren (100dB or more) 2. Tamper Spacer 3. Wall Tamper switch and Cover Tamper switch 4. Reset/Training switch 5. Tamper Switch connector 6. Battery pack (3 size “C” alkaline batteries) 7. Strobe lights 8. In-Field connector 9. Signal Strength and transmission LED 10. Antenna 11. LED Status Indicator 4 6 1 5 3 11 9 8 10 7 2