Pepperl+Fuchs PVS58X Series Manuals

1 Operating instructions Series PVS58X, PVM58X, PSS58X, PSM58X Germany: +49 621 776 1111 Pepperl+Fuchs Group Refer to "General Notes Relating to Pepperl+Fuchs Product Information". USA: +1 330 486 0001 Singapore: +65 6779 9091 www.pepperl-fuchs.com [email protected] [email protected] [email protected] DOCT-1761B / 07/17/2019 Safety recommendations for electrical apparatus to be used in hazardous areas The rotary encoder of the series PVS58X, PVM58X, PSS58X und PSM58X is an electrico-mechanical apparatus that converts rotational motion into electrical signals. Information on the gas-hazardous and dust explosion-hazardous area: Gas- and dust explosion protected zone 2 / zone 22 apparatus Declaration of conformity PF 19 CERT 5194 X Conformity 60079-0: 2012 +A11:2013, EN 60079-15: 2010, ignition protection class “n” EN 60079-31:2014, „protection by housing” Identification II 3G Ex nA IIB T4 Gc X II 3D Ex tc IIIC T120°C Dc X General technical information: Maximum rated operating voltage 10 to 30 Volt Permissible ambient temperature - 30°C to +55 °C Maximum momentary rated speed 6 000 RPM Degree of protection as per EN 60529 For P**58X-******0**-**** type Shaft-side IP64 (without shaft seal) Housing-side IP65 For P**58X-******W**-**** type Shaft-side IP66 (with shaft seal) Housing-side IP66 Maximum shaft load For PVS58X, PVM58X type Radial load 110 N Axial load 40 N For PSS58X, PSM58X type Angle offset ± 0,9° Axial offset static: ±0,3 mm, dynamic: ±0,1 mm Radial offset static: ±0,5 mm, dynamic: ±0,2 mm Commissioning and installation Information on hazardous areas and the manufacturer data sheets, as well as all laws or guidelines applying to use or planned application are to be followed. Standard 60079-14, in its valid version, is especially to be heeded. The device is to be shielded from strong electro-magnetic fields and from mechanical damage. The apparatus must be protected from excessive heat due to mechanical or electrical overloads. Application areas in which ambient conditions may damage the sealing material NBR are to be checked and avoided where pos- sible.