PerkinElmer S20 Series Manuals

S20 Series Autosampler Installation Guide Unpack and place the autosampler on the bench, as close as possible to the analytical instrument. To lift, place one hand under the back of the autosampler. Place the other hand along the front of the top cover to steady the autosampler. Do not lift by the removable tray. Gently tug the front of the removable tray upward to verify that it is firmly attached to the base of the autosampler. (Optional) If you need to re-seat the removable tray, lower it straight down then push it straight back. Insert the dual rinse station in the holder at the back left corner of the tray. Press straight down until it is fully seated. 1 2 5 TIP: If you find it difficult to get a good connection to the rinse station, remove the rinse station and press the tubing firmly so that it completely covers the barb of the fitting. It helps to use your other hand to apply counter- pressure. Connect the RINSE IN tubing to channels 2 and 3 of the peristaltic pump on the autosampler (2 mm I.D. pump tubing). Connect the WASTE tubing to channel 1, closest to the back of the autosampler (3.2 mm I.D. pump tubing). Ensure that the drain tubing is not submerged in the waste liquid. A dual-rinse, pumped-drain tubing arrangement is shown. Your application may need a different arrangement—see the User’s Guide. Carefully press the tubing straight on to the fittings as shown below. 3 4 Install the sample probe: Route the sample tubing through the loop on the Z-drive. Raise the slider on the Z-drive to its highest position and guide the probe straight down until the tip of the probe is level with the bottom of the Y arm. Tighten the two thumbscrews. Connect the power supply to the back of the autosampler. Connect the USB cable between the PC and autosampler. For ICP-MS with HTS, use a serial cable—see the User’s Guide. Turn on the autosampler. Turn the PC off then on to initialize communication. The autosampler is now ready to use. See the S20 Autosampler User’s Guide (on the included flash drive) for safety information, maintenance information, and detailed instructions. Consultez le « S20 Autosampler User’s Guide » (présent sur la clé USB fournie) pour les informations de sécurité, les informations d’entretien et des instructions détaillées. S23 autosampler after assembly. Standard Tubes Y Arm Z Drive Sample Tubing Sample Probe Sample Probe Holder Dual Rinse Station Sample Tubes Removable Sample Racks Removable Tray Z Y X 7 8 9 Part Number 09931598 Release A, February 2020 32-0775-048 Printed in USA 10 Sample Tubing Loop 6