Philips CED750/55 Manuals

Register your product and get support at CED750 ENG Quick Start Guide English Connect wires: ISO connectors 1 Pull out the ISO connectors from the car dashboard and connect them to the bigger end of the supplied standard connector. 2 Connect the other end of supplied standard connector to the unit. If necessary, connect the following: Connector Connect to/with 1 Black cable Antenna 2 Yellow cable Video out 1 3 Yellow cable Video out 2 4 Yellow cable Camera in 5 Green/white wire Parking 6 Black cable Bluetooth microphone 7 Blue cable Subwoofer 8 Red cable Front line out L 9 White cable Front line out R 0 Red cable Rear line out L ! white cable Rear line out R Mount in the dashboard Note Check wire connection before you mount the unit into a car. If preset radio stations are lost when the ignition key is turned OFF and then back ON, reconnect the red leads crosswise to the yellow ones. • • 1 If the car does not have an on-board drive or navigation computer, disconnect the negative terminal of the car battery. If you disconnect the car battery in a car that has an on-board drive or • • navigation computer, the computer may lost its memory. If the car battery is not disconnected, to avoid short-circuit, ensure that bare wires do not touch each other. 2 Ensure that car dashboard opening is within these measurements: Since the unit cannot be used if the dashboard opening’s slant angle is above 20 degrees: Ensure that the horizontal slant of the car dashboard opening is between 0 and 20 degrees 3 Remove the screws on the both side of the unit. 4 Remove the mounting sleeve. 5 Install the sleeve into the dashboard and bend the tabs outward to fi x the sleeve. 6 Place the rubber cushion over the end of the bolt. 7 Slide the unit into the dashboard until a click sound is heard. If the unit cannot fi t into the dashboard, remove the mounting bracket on the both side of the unit and replace them with the supplied short mounting brackets. 8 Attach the trim plate. 9 Reconnect the negative terminal of the car battery. Turn on 1 Press the to turn on the unit. The screen opens automatically. The available OSD (On-Screen Display) languages are displayed. 2 Touch a language to select. The OSD language is changed to the selected language immediately. To adjust the screen tilt, press TILT . To close the screen, press OPEN/CLOSE . To adjust the brightness/contrast, press / , then adjust 4 WAY NAVIGATION . To turn off the system, press for 3 sec- onds. The screen closes automatically. • • • » » » • • • • » Set clock 1 Touch to display main menu. 2 Touch [Setting]. The setup menu is displayed. 3 Touch [General]. 4 Touch the [Clock mode] repeatedly to select: [12hr] : 12 hour mode [24hr] : 24 hour mode 5 Touch the hour digits, then touch or . 6 Touch the minute digits, then touch or . 7 If 12 hour mode is selected, touch or to select AM or PM . 8 Touch to exit. Tune to a radio station 1 Touch to display the main menu. 2 Touch [Radio]. Band and frequency information is displayed. 3 Touch [Band] repeatedly to select: FM band options: FM1, FM2, FM3 AM band options: AM1, AM2 4 Briefl y touch [Previous] or [Next] to tune to a radio station by step. Play discs 1 Insert the disc into the disc slot with label side facing up. Play starts automatically. To remove the disc, press the button. When the disc is ejected, the unit switches to the previous source, if connected. Other- wise, the unit switches to [Radio] mode auto- matically. Insert USB or SD/MMC card 1 Open the USB/SD/MMC card cover. » • • » • • » » » 2 Insert the USB device or SD/MMC card in the USB socket or SD/MMC card slot. Play starts automatically. Pair the Bluetooth-enabled devices 1 Turn on the Bluetooth function on the device. 2 Setup the Bluetooth function on your devi 3 Select “CED750” in the pairing list. 4 Enter default password “0000”. iI pairing succeeds. [Connect] is display on the panel. Make a call 1 Pair the phone with the system. 2 Touch to return to main menu. 3 Touch [Bluetooth]. The Bluetooth menu is displayed. 4 Touch to dial. Receive call 1 If there is incoming call, [Incoming call…] fl ashes on the screen. Speak into the Blue- tooth microphone. 2 When conversation ends, touch to terminate the call. » » » 2 183 mm 53.5mm 5mm 1 1 2 3 4 5 6 7 8 9 0 ! 3 P r i n ti n g in C hi n a P r i n ti n g in C hi n a 4 © 2008 Koninklijke Philips Electronics N.V. All rights reserved. CED750 QSG_Eng.indd 1 CED750 QSG_Eng.indd 1 2008-11-14 2008-11-14

Register your product and get support at www.philips.com/welcome EN User manual CED750 EN i dd S 3 1 EN i dd S 3 1 2008 11 14 13 22 42 2008 11 14 13 22 42

CED750/55/98/51 DB-SL 0950 3141 785 33263 Exploded View & Parts List Version 1.3 9

CED750/55/98/51 DB-SL 0950 3141 785 33263 Exploded View & Parts List Version 1.3 9