Planet Technology VC-102M Manuals

Trademarks Copyright  PLANET Technology Corp. 2003. Contents subject to revise without prior notice. PLANET is a registered trademark of PLANET Technology Corp. All other trademarks belong to their respective owners. Disclaimer This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation, This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the Instruc­ tion manual, may cause harmful interference to radio communications, how­ ever, there is no guarantee that interface will not occur in a particular instal­ lation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on. CE Mark Warning This is a Class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures. Revision Ethernet Over VDSL Converter User’s Manual FOR MODELS: VC-102M / VC-102S Part No.: EM-VC102 Table of Contents Chapter 1 Introduction 1 1.1 Checklist 1 1.2 Introduction to Ethernet over VDSL Converter 1 1.3 Key Features 3 1.4 Specifications 4 Chapter 2 Hardware Description 7 2.1 Front Panel and Real Panel 7 2.2 The Rear Panel 9 Chapter 3 Installing and Using VDSL Converter 11 3.1 Install the Ethernet Over VDSL Converter 11 3.2 Connecting VC-102M/S 12 Chapter 4 Troubleshooting 15 1 Chapter 1 Introduction 1.1 Checklist Check the contents of your package for following parts: • Ethernet over VDSL Converter • Power Adapter • Telephone line • User’s Manual If any of these pieces are missing or damaged, please contact your dealer immediately, if possible, retain the carton including the original packing material, and use them against to repack the product in case there is a need to return it to us for repair. 1.2 Introduction to Ethernet over VDSL Converter The converter is a switching architecture with one RJ45 10/100Mbps Fast Ethernet ports and one RJ11 symmetric Ethernet over VDSL port (symmetry means upstream and downstream rate are the same or similar). It is ideal for signal conversion by transmitting the Ethernet data from the standard twisted pair cable to the telephone cable and extending the distance. The Ethernet over VDSL combines the well proven Ethernet and VDSL technology to transmit the Ethernet format data by using VDSL signaling over the most widespread telephone wires and has no impact to current voice service. Therefore, it is very good for Internet building phone line network because every room or house could use the existing phone line to transmit data to the Internet and the whole building could share the Internet line to the wide area network with minimum cost. With much enough bandwidth, the 5/10/15 Mbps symmetric capability enables many multi-media services on local Internet come true, like VOD (Video on Demand), Internet caching server, distance education, and so on. In one community or hotel, we just need to install one local server then the multi-media services will be localized that is people do not need to access the services through Internet but using local area network with better bandwidth and efficiency. Meanwhile, this kind of infrastructure will minimize the burden on the Internet. The converter is plug-n-play without any software to configure and also fully compliant with all kinds of network protocols. Moreover, the rich diagnostic LEDs on the front-panel provide the operating status of individual port and the whole system. There are two models of the converters, one is used for client side and the other is central side. If you want to setup one pair of converters for point-to-point connection then one set must be slave (client) mode and the other one is master mode. The cable specifications of the connection are listed as following: