Polaris 9400 Sport 4WD Manuals

9400 OWNER’S MANUAL English | Français | ESPAÑOL AVERTISSEMENT POUR VOTRE SÉCURITÉ – Pour toute opération autre que l’entretien de routine et la maintenance décrite dans ce manuel, ce produit doit être pris en charge par une entreprise qui est autorisée et qualifiée pour la réparation des équipements de piscine par la juridiction où le dit produit est installé lorsque de telles exigences locales ou provinciales sont édictées. Si aucune exigence locale ou provinciale n’est disponible, l’agent d’entretien doit être un professionnel avec suffisamment d’expérience dans l’installation et la maintenance d’équipement de piscine pour appliquer correctement les consignes du présent manuel. L’installation ou l’utilisation inappropriée annulera la garantie. WARNING FOR YOUR SAFETY - For anything other than the routine cleaning and maintenance described in this manual, this product must be serviced by a contractor who is licensed and qualified in pool equipment by the jurisdiction in which the product will be installed where such state or local requirements exist. In the event no such state or local requirement exists, the maintainer must be a professional with sufficient experience in pool equipment installation and maintenance so that all of the instructions in this manual can be followed exactly. Improper installation and/or operation will void the warranty. H0392900 Rev A 9400 Sport 4WD P94 4WD ADVERTENCIA PARA SU SEGURIDAD – Este producto debe ser instalado y mantenido por un contratista que está autorizado y calificado en equipo de piscina en las jurisdicción en la que el producto se instala donde existan requisitos estatales o locales. En el caso de ningún estado o locales obligatorio, el responsable debe ser un profesional con experiencia suficiente en la piscina de la instalación y mantenimiento de equipo para que todas las instrucciones en este manual puede ser seguido exactamente. Antes de instalar este producto, lea y siga todas las advertencias y las instrucciones qu acompañan a este producto. El incumplimiento de los avisos de advertencia e instrucciones puede resultar en daños a la propiedad, lesiones personales o la muerte. La instalación y/o operación se anulará la garantía. Page 2 English THANK YOU FOR PURCHASING THE POLARIS® 9400 4WD P94 4WD CLEANER. YOUR POLARIS ROBOTIC CLEANER HAS BEEN DESIGNED AND MANUFACTURED TO BE EASILY INSTALLED AND TO PROVIDE LOW MAINTENANCE OPERATION. PRIOR TO INSTALLING YOUR NEW POLARIS CLEANER, PLEASE DO THE FOLLOWING: 1) Complete and return the warranty card. 2) Record your purchase information on the spaces provided below. 3) Attach your invoice (or a copy) to this page. Taking these steps will help ensure prompt warranty service, should it be required. If service is required, please contact your original dealer. If the original dealer does not perform warranty service, please visit www.polarispool.com to locate an independent service company near you. If you are unable to locate a service company, please call our Technical Support department at 800-822-7933. RECORD YOUR POLARIS CLEANER DATA HERE: Date of Purchase Purchased From Serial Number: (located on machine head) City State/Province Zip/Postal Code Table of Contents Section 1. Important Safety Instructions......... 3 Section 2. Cleaner Specifications.................... 5 2.1 General Specifications........................................ 5 Section 3. Assembly.......................................... 5 3.1 Unpacking........................................................... 5 3.2 Assembling the Transport Caddy........................ 5 3.3 Connecting the Control Unit to the Caddy........... 7 3.4 Connecting to Power Source............................... 8 Section 4. Operation.......................................... 8 4.1 Submerging the Cleaner..................................... 8 4.2 Starting the Cleaning Cycle................................. 9 4.3 Stopping the Cleaner and Removing from the Pool......................................................11 4.4 Cleaning and Storing the Cleaner .....................11 Section 5. Programming Cleaning Cycles ..... 12 5.1 Displaying Current Day and Time...................... 12 5.2 Changing Day and Time.................................... 12 5.3 Setting Cleaning Cycles.................................... 12 5.4 Canceling Cleaning Cycles............................... 13 Section 6. Cleaning and Maintenance........... 14 5.1 Cleaning the Filter Canister............................... 14 5.2 Replacing the Brushes...................................... 15 5.4 Replacing the Tires............................................ 16 Section 7. Spare Parts..................................... 17 Section 8. Troubleshooting............................ 18 8.1 General Troubleshooting................................... 18 8.2 Control Unit Error Codes................................... 19 8.3 Viewing Cleaner Information for Troubleshooting................................................. 19 Page 3 English WARNING Failure to comply with the following warnings can result in permanent injury, electrocution or death. Prevent Electrical Shock To reduce risk of electrical shock: • Connect unit to receptacle protected by a ground fault circuit interrupter (GFCI). Such a GFCI receptacle should be provided by a qualified installer and should be tested on a routine basis. To test the GFCI, push the test button. The GFCI should interrupt power. Push the reset button. Power should be restored. If the GFCI fails to operate in this manner, the GFCI is defective. If the GFCI interrupts power to the pump without the test button being pushed, a ground current is flowing, indicating the possibility of an electric shock. Do not use this product. Disconnect the cleaner and have the problem corrected by a qualified service representative before using. • Per the United States National Electrical Code® (NEC®), keep the control unit at least five (5) feet from the edge of the (pool/spa) water. In Canada, the Canadian Electrical Code (CEC™) requires a minimum distance of 3m (10 ft.) to be maintained between the pool edge and the control unit. Never submerge the control unit. • Do not enter pool while the Polaris 9400 4WD / P94 4WD is in water. • Do not bury cord. Locate cord so as to prevent it from being damaged by lawn mowers, hedge trimmers and other equipment. • To reduce the risk of electrical shock, do not use the Polaris 9400 4WD / P94 4WD robotic cleaner or control unit if the cord is worn or damaged. Contact Zodiac Pool Systems, Inc. Technical Support immediately for proper servicing and replacement of the damaged cord. • Double insulation—For continued protection against possible electric shock, use only identical replacement parts when servicing. Do not attempt repair of the Polaris 9400 4WD / P94 4WD robotic cleaner, control unit, power cord, or floating cable. • NEVER OPEN CONTROL UNIT. • Do not use an extension cord to connect the unit to electric supply; provide a properly located GFCI RECEPTACLE. The control unit should be placed near the GFCI RECEPTACLE box. PREVENT CHILD INJURY AND DROWNING • To reduce the risk of injury, do not permit children to operate this product. • Do not let anyone, especially small children, sit, step, lean, or climb on any equipment installed as part of your pool’s operational system. Section 1. Important Safety Instructions Congratulations on purchasing the Polaris 9400 4WD / P94 4WD Robotic Cleaner. Please take a moment to read through the entire manual before installing your new robotic pool cleaner. Your cleaner must be installed and operated as specified. READ AND FOLLOW ALL INSTRUCTIONS Page 4 English SAVE THESE INSTRUCTIONS CAUTION Failure to comply with the following warnings could cause damage to pool equipment or personal injury. • The Polaris 9400 4WD / P94 4WD must be installed and operated as specified. • This product is intended for use with permanently-installed pools. Do not use with storable pools. A permanently-installed pool is constructed in or on the ground or in a building such that it cannot be readily disassembled for storage. A storable pool is constructed so that it is capable of being readily disassembled for storage and reassembled to its original integrity. • Clean the filter canister in the Polaris 9400 4WD / P94 4WD after each use. • Do not use the product in your pool if the water temperature is above 95˚ F (35˚ C) or below 55˚ F (13˚ C). CAUTION USE OF THE POLARIS 9400 4WD / P94 4WD ROBOTIC CLEANER IN A VINYL LINER POOL Certain vinyl liner patterns are particularly susceptible to rapid surface wear of pattern removal caused by objects coming into contact with the vinyl surface, including pool brushes, pool toys, floats, fountains, chlorine dispensers, and automatic pool cleaners. Some vinyl liner patterns can be seriously scratched or abraded simply by rubbing the surface with a pool brush. Ink from the pattern can also rub off during the installation process or when it comes into contact with objects in the pool. Zodiac Pool Systems, Inc., is not responsible for, and the Limited Warranty does not cover, pattern removal, abrasion or markings on vinyl liners.