Power Team PE30-HOGEN Manuals

ELECTRIC HYDRAULIC PUMP Max. Capacity: 10,000 PSI Read and carefully follow these instructions before installation and use of this pump. Most problems with new equipment are caused by improper operation and installation. SAFETY PRECAUTIONS G All WARNING statements must be carefully observed to help prevent personal injury. Hydraulic Hose G Before operating this pump, tighten all hose connections using the proper tools. Do not overtighten the connections. Connections need only be tightened securely and leak-free. Overtightening may cause premature thread failure or high pressure fittings to split at pressures lower than their rated capacities. G Should a hydraulic hose ever burst, rupture, or need to be disconnected, immediately shut off the pump. Never attempt to grasp a leaking hose under pressure with your hands. The force of the escaping hydraulic fluid could cause serious injury. G Do not subject the hose to potential hazard such as fire, extreme heat or cold, sharp surfaces, or heavy impact. Do not allow the hose to kink, twist, curl or bend so tightly that the oil flow within the hose is blocked or reduced. Periodically inspect the hose for signs of wear because any of these conditions can damage the hose and may result in personal injury. G Do not use the hose to move attached equipment. Stress may damage the hose and cause personal injury. G Hose material and coupler seals must be compatible with the hydraulic fluid used. Hoses also must not come in contact with corrosive materials such as creosote-impregnated objects and some paints. Consult the manufacturer before painting a hose. Never paint the couplers. Hose deterioration due to corrosive materials may result in personal injury. Pump G Do not exceed the PSI hydraulic pressure rating noted on the pump nameplate or tamper with the internal high pressure relief valve. Creating pressure beyond rated capacities may result in personal injury. G Before replenishing the oil level, retract the system to prevent overfilling the pump reservoir. An overfill may cause personal injury due to excess reservoir pressure created when cylinders are retracted. Cylinder G Do not exceed rated capacities of the cylinders. Excess pressure may result in personal injury. G Do not set poorly-balanced or off-center loads on a cylinder. The load may tip and cause personal injury. Electrical Supply G Do not use an ungrounded (two-prong) extension cord. G Avoid conditions which could create an electrical hazard. G If the power cord is damaged or wiring exposed, replace or repair immediately. Form No. 102838 Operating Instructions for: PE30-HOGEN PE302 PE302-2 PE302S-CODHE PE303 PE303-2 PE304 PE304-2 PE304ML PE302S-Tyco PE302S-CODHE-115 PE302A-2-TRANS Sheet No. 1 of 3 Rev. 7 Date: 25 May 2012 WARNING © SPX Corporation