Primos 62704 Manuals

Sit’N Spin Crazy Critter™ Instructions Model# 62704 Battery Installation: Step 1 - Unscrew the bottom housing cap as shown in Fig. 1, then remove and set aside the exposed screw in the center of the battery compartment cover. Step 2 - Remove the battery compartment cover (you may need a small flat screwdriver or pocketknife tip to lift up an edge of the cover). Insert 4 AA batteries (not included) in battery compartment, following the polarity marks (flat “-” ends facing springs)-see Fig. 2. Step 3 - Replace battery compartment cover and screw at center of cover. Step 4 - Replace bottom housing cap. Setup: Step 1 - Attach Fur Critter: a) Remove fur critter with spring wire from its storage clips. b) Loosen thumb screw on critter connection. c) Insert spring wire into critter connection and tighten thumb screw. Step 2 - Attach Ground Stake: a) Remove ground stake from its storage clip. b) Thread ground stake into bottom housing. Operation: Turn On – Turn speed dial (Fig. 3) clockwise. a) Increase variable Speed – Turn speed dial clockwise. b) Decrease variable Speed – Turn speed dial counter clockwise. Turn Off – Turn speed dial counter clockwise until it clicks to off position. Using Sit’N Spin Crazy CritterTM: Insert Sit’N Spin Crazy CritterTM ground stake firmly into ground along field edges, in fields or in wooded areas so it can be seen by predators. Set desired motion speed and start hunting. The new and improved Sit and Spin Crazy CritterTM includes a remote control 3.5mm jack. This jack and included 3.5mm cable can be used to connect your decoy to your Primos Electronic Caller and control the decoy with the caller remote. Compatible with Primos Alpha DoggTM, Turbo DoggTM and Boss DoggTM. Check the Primos website for the most recently updated list of compatible electronic callers. Primos® Hunting 604 First St., Flora, MS 39071 (601) 879-9323 www.primos.com TM Fig. 1 Fig. 2 Fig. 3 rev110716